Abstract:The thermoelectric properties of the clathrate compounds Ba8ZnxGe46−x were studied theoretically and experimentally. First, a first-principles electronic structure calculation was performed. The calculated result showed that Ba8Zn8Ge38 is an intrinsic semiconductor with an indirect band gap, while Ba8Zn6Ge40 is an n-type degenerate semiconductor and Ba8Zn10Ge36 is a p-type degenerate semiconductor. A large x dependence for the band gap was found between x=6 and 8, i.e., the widths of band gap Eg at x=6, 8 and 10 were 0.83 eV, 0.40 eV, 0.35 eV, respectively. Thus, for a thermoelectric material with high performance at high temperatures, the band gap of the intrinsic semiconductor Ba8Zn8Ge38 is relatively small. On the other hand, it was found that the double substituted clathrate Ba8Zn6Ga4Ge36 is an intrinsic semiconductor with a relatively large band gap: Eg=0.69 eV. Second, we synthesized Zn substituted clathrate compounds by using the mechanical alloying and spark plasma sintering method, and measured the thermoelectric properties of the synthesized samples to show the concrete advantage of the Ba-Zn-Ga-Ge system. The experimental results showed that all of the Ba8ZnxGe46−x (x=6,8,10,12) samples were n-type semiconductors, and that some of the Zn clathrates (x=6∼10) had a reasonably good n-type thermoelectric ability. Moreover, it was confirmed that the band gap of Ba8Zn6Ga4Ge36 (Eg=0.9 eV) is wider than that of Ba8Zn8Ge38 (Eg=0.4 eV), and that Ba8Zn6Ga4Ge36 has better thermoelectric characteristics than Ba8Zn8Ge38 at high temperatures. Finally, the experimental thermoelectric properties were theoretically analyzed by using the results of the electronic structure calculation and good agreement was obtained.

Theoretical Studies on the Thermoelectric Properties of Tin-based Clathrates: CS8M4Sn42 (M = Zn, Cd, Hg) and CS8Sn44 square(2)

Theoretical Studies on the Thermoelectric Properties of Tin-based Clathrates: Cs 8 M 4 Sn 42 (M = Zn, Cd, Hg), Cs 8 Sn 44 □ 2

Thermoelectric Properties of Strained -Cu<sub>2</sub>Se

Eco-friendly P-Type Cu2SnS3 Thermoelectric Material: Crystal Structure and Transport Properties

Potential thermoelectric materials $\mathrm{CsMI_3}$ (M=Sn and Pb) in perovskite structures from the first-principles calculations

Thermoelectric performance of (AgBiTe2)1-x(SnTe)x with stable cubic enabled by enhanced configurational entropy

Study of Zn-Substituted Germanium Clathrates as High Performance Thermoelectric Materials Assisted by First-Principles Electronic Structure Calculation

Thermoelectric and lattice dynamics properties of layered MX (M = Sn, Pb; X = S, Te) compounds

First-principles Calculations to Investigate Probing the Influence of Mn and Mg Doping Concentration on Electronic Structures and Transport Properties of SnTe Alloys

Valence band engineering and thermoelectric performance optimization in SnTe by Mn-alloying via a zone-melting method

Theoretical Investigation on Thermoelectric Properties of Cu-Based Chalcopyrite Compounds

Realizing high-ranged thermoelectric performance in PbSnS2 crystals

A DFT Computational Study of Type-I Clathrates A8Sn46−x (A = Cs or NH4, x = 0 or 2)

Tuning the Thermoelectric Properties of Ca9zn4+Xsb9 by Controlled Doping on the Interstitial Structure

Thermoelectric Properties Of Sn-Doped P-Type Cu3sbse4: A Compound With Large Effective Mass And Small Band Gap

Thermoelectric power factor of pure and doped ZnSb via DFT based defect calculations

First-Principles Thermoelectric Study of SrMgSi and CaMgGe Zintl-Phase Compounds

Planar Zintl-phase high-temperature thermoelectric materials XCuSb (X = Ca, Sr, Ba) with low lattice thermal conductivity

Electronic Orbital Alignment and Hierarchical Phonon Scattering Enabling High Thermoelectric Performance p-Type Mg 3 Sb 2 Zintl Compounds

Low Lattice Thermal Conductivity and High Thermoelectric Figure of Merit in Na2MgSn

High Thermoelectric Figure of Merit ZT > 1 in SnS Polycrystals