Abstract:Abstract Ion-induced secondary electron emission at a target surface is an essential mechanism for laboratory plasmas, i.e. magnetron sputtering discharges. Electron emission, however, is strongly affected by the target condition itself such as oxidation. Data of oxidized targets, however, are very sparse and prone to significant systematic errors, because they were often determined by modeling the complex behavior of the plasma. Thus, it is difficult to isolate the process of ion-induced electron emission from all other plasma-surface-interactions. By utilizing ion beams, the complex plasma environment is avoided and electron yields are determined with higher accuracy. In this study, ion-induced secondary electron emission coefficients (SEECs) of clean, untreated (air-exposed), and intentionally oxidized copper and nickel surfaces were investigated in such a particle beam experiment. Pristine and oxidized metal foils were exposed to beams of singly charged argon ions with energies of 0.2 keV - 10 keV. After the ion beam treatment, the surface conditions were analyzed by ex-situ x-ray photoelectron spectroscopy measurements. Further, a model for the electron emission of a partly oxidized surface is presented, which is in agreement with the experimental data. It was found, that oxidized and untreated/air-exposed surfaces do not show the same SEEC: for intentionally oxidized targets, the electron yields were smaller by a factor of 2 than for untreated/air-exposed surfaces. SEECs of oxides were found to be between the values for clean and for untreated metal surfaces. Further, the SEEC was at maximum for untreated/air-exposed surfaces and at minimum for clean surfaces; the electron yields of untreated/air-exposed and clean surfaces were in agreement with values reported in the literature.

Secondary Electron Emission Yield Measurement of Dielectric Materials for Satellite Antenna

Systematic Study of Spontaneous Emission in a Two-Dimensional Arbitrary Inhomogeneous Environment

Measurement of dielectric conductivity for assessment of deep charging

The Dose Effect in Secondary Electron Emission

Design and Research of Secondary Electron Emission Test Equipment with Low Electron Energy

Dog bite of the face in an adult Nigerian--a case report.

Measurements of the Secondary Electron Emission of Some Insulators

Report on Instrumentation and Methods for In-Situ Measurements of the Secondary Electron Yield in an Accelerator Environment

The Effect of Magnetic Field on the Secondary Electron Yield in the Ultra-High Vacuum Environment

Measurements of the Secondary Electron Emission from Rare Gases at 4.2K

Variation of Permittivity and Dark Conductivity of Polyimide and FR4 with Electron Dose by Experiments

On the in-situ determination of the effective secondary electron emission coefficient in low pressure capacitively coupled radio frequency discharges based on the electrical asymmetry effect

Secondary electron emission from insulators and negative electron affinity semiconductors

Secondary Electron Emission from Surfaces with Small Structure

Research on the secondary electron yield of TiZrV-Pd thin film coatings

Novel types of anti-ecloud surfaces

Ion-induced secondary electron emission of oxidized nickel and copper studied in beam experiments

Incident beam current impact on space-charge retention in electron dynamitron irradiated polymethyl methacrylate

Investigation of Electrons Inside the Satellite by the Geant4 Simulation

Monitoring Deep Dielectric Charging Effects in Space

Deep Dielectric Charging Effect Measurement Using DDCE Monitor