Abstract:Electron beam selective melting (EBSM), is powder bed fusion additive manufacturing (AM) technique by adding materials layer upon layer. The capacity of EBSM to fabricate complex and multi-functional parts has made it a realm of great interest for researchers in the domain of science. However, during the fabrication of functionally graded materials (FGMs) with graded composition by EBSM using at least two different materials, it is difficult to separate and reuse these materials after the fabrication. Additionally, it is difficult to vary the powder composition within a layer to fabricate a horizontal graded structure. In this research, an element evaporation concept based on electron beam powder bed fusion, is presented for fabricating one-dimensional (1D) FGMs of (α2 + γ) TiAl alloy/(α + β) titanium alloy from a single material powder. By irradiating different sub-regions of the powder bed with electron beam energy input of different magnitude to greatly reduce the relative atomic ratio of aluminum from 47% to less than 10%, the 1D FGMs structures with (α2 + α + β) phases in the interfacial transition zone (ITZ) were successfully produced. Since the microstructure of the ITZ has a significant effect on mechanical properties for the 1D FGMs, three different overlap scan distances (0.5, 1.0 and 2.0 mm), which result in different ITZs, were utilized for evaluating the microstructure of the ITZ and resulting mechanical properties. The results showed that no defects were found in the specimens of any overlap distance. Moreover, the width of the ITZ increases as the overlap scan distance, and the tensile strength decreases with the overlap scan distance.

Fabrication of ZrO2/Mo-Si/Ni Functionally Graded Material by Dip-Coating

Fabrication and Characterization of Y2O3 Stabilized ZrO2 Films Deposited with Aerosol-Assisted MOCVD

Fabrication process of smooth functionally graded materials through a real-time inline control of the component ratio

A functionally graded coating from ZrN to Ti: Experimental characterization, erosion behavior and design concept

Al2O3/ZrO2 Functionally Graded Material Made by Extrusion Gelation Freeforming Processing

Microstructures of Ni–ZrO2 functionally graded materials fabricated via slip casting under gradient magnetic fields

A New Approach for the Preparation of Functionally Graded Materials Via Slip Casting in a Gradient Magnetic Field

Fabrication of SiC/Al functionally graded materials via filtration extrusion

Fabrication and characterization of stainless steel 308 L / Inconel 625 functionally graded material with continuous change in composition by dual-wire arc additive manufacturing

Structure and Properties of Particles/rubber Composites Applied on Functionally Graded Lapping and Polishing Plate

FABRICATION AND CHARACTERIZATION OF FUNCTIONALLY GRADED Ni–Ti MULTILAYER THIN FILMS

Integrated preparation and enhanced performance of high-melting-point ZrC–Mo multilayer graded materials

PREPARATION AND MICROSTRUCTURE OF Ti-ZrO2 GRADIENT MATERIALS

Synthesis of Functionally Graded AA7075-B4C Composite with Multi-Level Gradient Structure

Fabrication of functionally graded materials from a single material by selective evaporation in electron beam powder bed fusion

Formation Kinetics and Properties of CrNx/H13 Functionally Graded Coating Fabricated by PVD

Characterization of Interfacial Transition Zone of Functionally Graded Materials with Graded Composition from a Single Material in Electron Beam Powder Bed Fusion

Fabrication and Micro-Structure of a Multilayer Functionally Graded (wc–co)–ni Composite

Characterization of a functionally graded material produced using a new designed blender

Fabrication and properties of symmetrical W/Si3N4/W functionally graded materials by spark plasma sintering

A functionally graded material design from stainless steel to Ni-based superalloy by laser metal deposition coupled with thermodynamic prediction