Abstract:The mechanism of explaining liquid friction and flux consumption in a non‐sinusoidal oscillation mould is expounded by proposing a series of indices for estimating interface phenomena between mould and metal in meniscus and calculating the effect of non‐sinusoidal oscillation parameters on these indices. The results show that the liquid flux is periodically infiltrated into the gap between oscillating mould and withdrawing slab by the negative pressure caused by widening flux channel from the last stage of positive strip time to the last stage of negative strip time. The surface cracks on the slab, even breakout, are formed during the positive strip time and existing surface cracks can be healed within the cumulative negative strip time. The casting performances were improved by decreasing oscillation frequency and increasing amplitude and non‐sinusoidal oscillation factor. On explique la friction liquide et la consommation de flux dans une coquille à oscillation non‐sinusoïdale en proposant une série d’indices pour estimer les phénomènes d’interface entre la coquille et le métal dans le ménisque et pour calculer l’effet des paramètres d’oscillation non‐sinusoïdale sur ces indices. Les résultats montrent que le flux liquide s’infiltre périodiquement dans l’espace entre la coquille oscillante et la brame en retrait par la pression négative causée par l’élargissement du canal de flux à partir de la dernière étape de temps positif de démoulage jusqu’à la dernière étape de temps négatif de démoulage. Les fissures de surface de la brame, et même la percée, sont formées lors du temps positif de démoulage et les fissures de surface existantes peuvent être réparées lors du temps négatif cumulatif de démoulage. Le rendement du moulage s’améliorait en diminuant la fréquence d’oscillation et en augmentant l’amplitude et le facteur d’oscillation non‐sinusoïdale.

Online Monitoring System for Mould Friction Based on Hydraulic Oscillation in Slab Continuous Casting

Research and Development of the Online Vibration Monitoring System for Continuous Casting Mold

Investigation on non-uniform friction behaviors of slab during continuous casting based on an inverse algorithm

Application of Mould Hydraulic Width-adjust Technique in Slab Caster

NUMERICAL SIMULATION OF SURFACE OSCILLATION IN CONTINUOUS CASTING MOLD

Elastodynamic Analysis of Synergistic Oscillation System Driven by Double Servomotors for Continuous Casting Mold

Continuous casting slag carry-over detection system based on vibration signal measurement

Mechanism of explaining liquid friction and flux consumption during non‐sinusoidal oscillation in slab continuous casting mould

Time–Frequency Characteristics and Predictions of Instantaneous Abnormal Level Fluctuation in Slab Continuous Casting Mold

Modeling and Simulation of the Fluid Flow in Continuous Slab Casting Mould

Synchronous Control Model and Oscillation Principle of Swing Crank Type for Continuous Casting Mold

A coupled model on fluid flow, heat transfer and solidification in continuous casting mold

Thermo-mechanical Modeling in Continuous Slab Casting Mould and Its Application

Instability Of Fluid Flow And Level Fluctuation In Continuous Thin Slab Casting Mould

A mathematical mould model for transient infiltration and lubrication behaviour of slag in a steel continuous casting process

Temperature Distribution and Dynamic Control of Secondary Cooling in Slab Continuous Casting

Analysis of the Transient Phenomena During Steel Continuous Casting Through the On‐line Detection Data

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Hydraulic Modeling on Flow Behavior in High-Speed Billet Continuous Casting Mold Considering Hydrostatic Pressure and Solidified Shell

Numerical Study on Characteristic Positions and Transition of Flow Patterns in a Slab Continuous Casting Mold

Numerical Simulation on Free Surface in the Mold of Slab Continuous Caster at Low Casting Speed with MFCD