Abstract:Despite zirconia (ZrO2) ceramics and lithium disilicate (Li2Si2O5) glass-ceramics have been widely applied on the market for dental restorations, composites that can combine the advantages of both are still demanded. Here we introduced a ZrO2-Li2Si2O5 ceramic with minimized glass phases that fabricated through a sol-gel method and subsequent pressureless sintering. ZrO2-Li2Si2O5 powders were obtained after the gel precursors were heat treated under 800 °C. The gel-derived powders were molded and pressureless sintered under 900-1000 °C to investigate their sintering properties. From the microstructures of the sintered samples, we knew that the densification process was dominated by the growth of Li2Si2O5 grains instead of the growth of ZrO2 grains. Increasing in Li2Si2O5 content can promote ceramic densification. Interestingly, reactions between ZrO2 and Li2Si2O5 were observed with sintering temperature higher than 916 °C, which can increase the porosity of the ceramics. Therefore, both the content of Li2Si2O5 and sintering temperature should be well adjusted to achieve samples with desired properties. Finally, ceramics with flexural strength of 226 MPa and porosity of 0.4% were achieved from powders with moderate Li2Si2O5 content after sintering at 1000 °C.

Preparation of SiC Ceramics by Laminated Object Manufacturing and Pressureless Sintering

Preparation of HEMA gel-casted SiC ceramics combined with LPS sintering

Preparation of low residual silicon content Si-SiC ceramics by binder jetting additive manufacturing and liquid silicon infiltration

Al2O3 Ceramics Preparation by LOM (laminated Object Manufacturing)

Fabrication, Structure and Properties of Porous SiC Ceramics with High Porosity and High Strength

Enhanced Molding and Mechanical Properties of SiC-based Ceramic Lattice Structures Via Digital Light Processing

Preparation of Porous SiC Ceramic Using Bamboo Charcoal and Silica Sol As Pore-Forming Agents

Sol-gel preparation of ZrO2–Li2Si2O5 ceramics and their sintering properties

THE MICROSTRUCTURE AND THE PROPERTY OF SiC/Si LAMINATED CERAMIC COMPOSITES FROM PAPER

Ceramic green tape extrusion for laminated object manufacturing

Low-temperature preparation of porous SiC ceramics using phosphoric acid as a pore-forming agent and a binder

The Fabrication and Mechanical Properties of SiC/ZrB2 Laminated Ceramic Composite Prepared by Spark Plasma Sintering

Laminated Fabrication Ceramics by Aqueous Tape Casting Technology

Toughness and R-curve behaviour of laminated Si3N4/SiCw ceramics

Stereolithography-based additive manufacturing of lightweight and high-strength Cf/SiC ceramics

Properties regulation of SiC ceramics prepared via stereolithography combined with reactive melt infiltration techniques

Microstructure Evolution and Performance Improvement of Silicon Carbide Ceramics via Impregnation Method

Study on Micro-structure and Properties of Al2O3/SiC Ceramics by Pressureless Sintering in Air

Mechanical properties and forming conditions optimization of SiC ceramics using Camellia oleifera shell as carbon source

Fabrication of Si3N4 ceramics substrates with high thermal conductivity by tape casting and gas pressure sintering

PREPARATION AND CHARACTERIZATION OF SiC POROUS CERAMICS SUPPORT