Abstract:The mechanical performances of composite materials are largely dependent on their interfacial properties in composite structure design. The interfacial failure behaviors of sisal fiber reinforced composites (SFRCs) were investigated experimentally and theoretically in present study. Single fiber pull-out experiments were performed on sisal fibers with the multi-layer structure. To gain insight into the multi-layer interfacial failure mechanisms of SFRCs, acoustic emission (AE) technique was employed on monitoring and characterizing the multi-stage fracture performance observed in the pullout process. The energy emission for multi-stage fracture of SFRC was observed to gradually reduce due to their decreased residual pullout strength. Different failure sequences of SFRCs were described with the help of AE. Based on the above results, statistical analysis was used to evaluate the probability of technical fiber, elementary fiber and microfibril pullout. The results indicated that technical fiber was more likely to be pulled-out from matrix since the interfacial bonding between sisal fiber and matrix was relatively poor for untreated sisal fiber while elementary fiber and microfibril could also be pulled-out from technical fiber owing to the existence of the multi-layer interface. Meanwhile, based on the traditional shear lag model, a three-interface finite element model, regarding multi-stage fracture of the three interfaces, was established to interpret the multi-layer failure phenomenon and estimate the stress variation of SFRCs during the single sisal fiber pull-out process. Quantitative comparison between the numerical simulation of three-interface model and that of single and double interface models, using the experimental applied stress as reference, surmised that single, double and three-interface model need to be comprehensively considered to describe the pullout behaviors of SFRCs for providing more accurate solutions. It was shown that a good agreement was obtained by comparing numerical modelling results with experimental ones in the single fiber pull-out tests.

Comparison of the Stress Transfer in Single- and Multi-Fiber Composite Pull-out Tests

Analyses of the Micromechanics of Stress Transfer in Single- and Multi-Fiber Pull-Out Tests

Stress Transfer of Single-Fiber VS Multi-Fiber

On the Elastic Stress Transfer and Longitudinal Modulus of Unidirectional Multi-Short-fiber Composites

Keynote: EXPLICIT MODELLING OF FIBRE PULLOUT IN CEMENTITIOUS COMPOSITES

STUDY OF INTERFACIAL STRESS OF SINGLE-FIBER COMPOSITE BY PHOTO-ELASTIC EXPERIMENT

Coulomb frictional interfacial stresstransfer in fiber pull-out

Theoretical Study of the Stress Transfer in Single-Fibre Composites. Part II. Partially Debonded Fibre-Matrix Interface

Interfacial Stress Transfer Behavior in a Specially-Shaped Fiber/matrix Pullout Test

Analysis of the Interface Shear Strength of Boron Fiber/Epoxy Composites Based on Single -fibre Push-out Test

Interfacial Stress Transfer Behavior of Single-Fiber Composite under the Effect of Mechanical and Thermal Loading

The fibre pull-out energy of misaligned short fibre composites

On The Pull-Out Of Fibers With A Branched Structure And The Inference Of Strength And Fracture-Toughness Of Composites

A novel approach based on stress-impedance effect to assess the interfacial properties in fiber-reinforced composites

TEST AND ANALYSIS OF INTERFACIAL SHEARING STRENGTHS OF DIFFERENT LEVELS FOR FINE WEAVE & PIERCED CARBON/CARBON COMPOSITES

Analyses of elastic stresses of fiber reinforced composite

A Comparative Study on the Pullout Behavior of Hooked-End Straight and Arc-Shaped Steel Fibers from Brittle SIFCON Matrices under the Influence of Adjacent Fibers

Stress transfer of a Kevlar 49 fiber pullout test studied by micro-Raman spectroscopy.

Frictional pull-out work capacity of macro-SSF in concrete composites and evaluation of matrix deterioration due to kinematic fiber-end-slip after full-debonding point

The investigations of multi-layer interface failure behavior for sisal fiber reinforced composites via acoustic emission and finite element method

Measurement and analysis of fiber-matrix interface strength of carbon fiber-reinforced phenolic resin matrix composites