Abstract:The single fiber/microdroplet tensile test is applied for evaluating the interfacial mechanics between a fiber and a resin substrate. It is used to investigate the influence of a polymer coating on a Kevlar-29 fiber surface, specifically the stress transfer between the fiber and epoxy resin in a microdroplet. Unlike usual tests, this new test ensures a symmetrical axial stress on the embedded fiber and reduces the stress singularity that appears at the embedded fiber entry. Using a homemade loading device, symmetrical tensile tests are performed on a Kevlar-29 fiber with or without polyvinylchloride (PVC) coating, the surface of which is in contact with two epoxy resin microdroplets during curing. Raman spectra on the embedded fiber are recorded by micro-Raman Spectroscopy under different strain levels. Then they are transformed to the distributions of fiber axis stress based on the relationship between stress and Raman shift. The Raman results reveal that the fiber axial stresses increase with the applied loads, and the antisymmetric interfacial shear stresses, obtained by a straightforward balance of shear-to-axial forces argument, lead to the appearance of shear stress concentrations at a distance to the embedded fiber entry. The load is transferred from the outer fiber to the embedded fiber in the epoxy microdroplet. As is observed by scanning electronic microscopy (SEM), the existence of a flexible polymer coating on the fiber surface reduces the stress transfer efficiency.

Stress transfer of a Kevlar 49 fiber pullout test studied by micro-Raman spectroscopy.

Raman Measurements of Kevlar-29 Fiber Pull-out Test at Different Strain Levels

Stress Transfer of Single Fiber/microdroplet Tensile Test Studied by Micro-Raman Spectroscopy

Stress Transfer in Microdroplet Tensile Test: Pvc-Coated and Uncoated Kevlar-29 Single Fiber

Micromechanics Analysis of Kevlar-29 Aramid Fiber and Epoxy Resin Microdroplet Composite by Micro-Raman Spectroscopy

Pullout Strength of Graphene and Carbon Nanotube/epoxy Composites

Interfacial Stress Transfer Behavior in a Specially-Shaped Fiber/matrix Pullout Test

Coulomb frictional interfacial stresstransfer in fiber pull-out

Stress Transfer of Single Yarn Drawing in Soft Fabric Studied by Micro Raman Spectroscopy

Full-field Fabric Stress Mapping by Micro Raman Spectroscopy in a Yarn Push-out Test.

On the Tensile Deformation Behavior of M55JB Carbon Fiber/Microdroplet Based on Micro-Raman Spectroscopy

In situ interfacial evaluation of aramid/epoxy composites by interfacial stress transfer characteristics

Multi-fiber Strains Measured by Micro-Raman Spectroscopy: Principles and Experiments

Analyses of the Micromechanics of Stress Transfer in Single- and Multi-Fiber Pull-Out Tests

Micromechanics of Single Fiber-Crack Interaction: Completely Bonded Fiber

Experimental Study of Yarn Friction Slip and Fabric Shear Deformation in Yarn Pull-out Test

Kevlar 49 Yarn Pull-out Test and Numerical Analysis

STUDY OF INTERFACIAL STRESS OF SINGLE-FIBER COMPOSITE BY PHOTO-ELASTIC EXPERIMENT

A Dynamic Small Angle X-Ray Scattering Study of Stressed Kevlar® 49/Epoxy Composites

Shear Deformation and Energy Absorption Analysis of Flexible Fabric in Yarn Pullout Test

Analysis of the Interface Shear Strength of Boron Fiber/Epoxy Composites Based on Single -fibre Push-out Test