Abstract:Si-modified NiAl coating has been studied by researchers due to its good performance in high temperature corrosive environment, but the effect of Si content on the high temperature oxidation resistance of the aluminide coatings has been seldom studied. To figure out this issue, three modified NiAl coatings with different Si contents were prepared by varying the Si contents 8wt%, 17wt% and 30 wt% in the slurry. Phase structures and microstructures of the simple NiAl coatings and three Si-modified NiAl coatings before and after oxidation were analyzed by XRD, SEM and EPMA, etc. The results show that the delta-Ni2Al3 and ss-NiAl are the primary phases of the four aluminide coatings. Si mainly locates in the upper zone of the Si-modified NiAl coatings in the form of silicides as CrSi2, Cr5Si3 and Ni2Si. After oxidation at 1000. for 500 h, the simple NiAl coating has the maximum mass gain of 1.93 mg/cm(2), while the Si-modified NiAl coating with Si content of 8wt% has the smallest mass gain. The dopant of Si into NiAl coatings can promote the formation of protective alpha-Al2O3 film, retard the outward diffusion of refractory metal elements and improve the surface quality of the oxide film, resulting in reduced oxidation rate. However, the addition of Si reduces the Al content on the surface layer of the coating and may make the coating insufficient of ss phase to maintain the selective oxidation of Al in the later period of long- time oxidation. Therefore, when the Si content is 8wt%, the Si-modified NiAl coating possesses the best oxidation resistance.

High-Performance Al–Si Coatings Toward Enhancing Oxidation Resistance of Tungsten by Halide-Activated Pack Cementation

Microstructure and oxidation behavior of SiOC coatings on C/C composites co-deposited with HMDS and TEOS by using CVD process

Oxidation behavior of the CVD-Al2O3 coatings on tungsten substrate at 1000 °C

Structure and High-Temperature Oxidation Performance of Si-Co Diffusion Coatings Prepared on a TiAl-Nb Alloy

Improving the high temperature oxidation resistance of TiAl alloy by SiOC coating

High temperature oxidation behavior of TiAl alloy with electrodeposited SiOC coating

Investigation of the Role of Silicon in TiAlSiN Coating Deposited on TiAl Alloys during Long-term Oxidation

Improving oxidation resistance of γ-TiAl based alloy by depositing TiAlSiN coating: Effects of silicon

High temperature oxidation behavior of MoSi2–Al2O3 composite coating on TZM alloy

Oxidation Behavior of (Mo,Hf)Si2-Al2O3 Coating on Mo-Based Alloy at Elevated Temperature

Cyclic oxidation behavior of Al-Si coating on new γ′-strengthened cobalt-based superalloy: Experimental study and first-principles calculation

High Temperature Oxidation Resistance and Degradation Mechanism of Al-Si Coatings on Nickel-Based Superalloy at 1000.

Improving oxidation resistance of TZM alloy by deposited Si–MoSi2 composite coating with high silicon concentration

Microstructure and high-temperature oxidation behavior of Ti3AlC 2/W composites

Microstructure and oxidation resistance of Si-MoSi2 ceramic coating on TZM (Mo-0.5Ti-0.1Zr-0.02C) alloy at 1500 °C

Microstructure and Composition Evolution of a Fused Slurry Silicide Coating on MoNbTaTiW Refractory High-Entropy Alloy in High-Temperature Oxidation Environment

Study on the Oxidation Behavior of TiB2-CeO2-Modified (Nb,Mo,Cr,W)Si2 Coating on the Surface of Niobium Alloy

The influence of silicon content on the microstructure and high‐temperature oxidation behavior of aluminum‐silicon coatings on Ti‐6Al‐4 V alloy by hot dipping route

Effect of Al2O3 addition on the microstructure and oxidation behavior of SiC coating prepared by pack cementation on C/C composites

Preparation of in-situ synthesized TiC/AlSi30Cu5 coating by high velocity oxy-fuel (HVOF) spraying: Microstructure evolution, mechanical properties, and tribological behavior

Structural and High-Temperature Oxidation Performance of Al-Co-Y Co-deposited Coatings on a TiAl-Nb Alloy at Low Temperatures