Effect of WC addition on microstructure and properties of laser melting deposited Ti6Al4V
Yanhua Guo,Xianxiang Lu,Wei Han,Jin Min,Guoqing Dai,Zhonggang Sun,Hui Chang,Yidong Xia
DOI: https://doi.org/10.1016/j.matchar.2024.114344
IF: 4.537
2024-09-08
Materials Characterization
Abstract:Titanium alloys are generally characterized by low surface hardness, poor thermal conductivity, high friction coefficients and susceptibility to adhesive wear, which significantly hinder their industrial applications. To address this issue, we enhance the wear resistance of titanium alloys by incorporating nano WC particles. However, the optimal amount of WC to be added to titanium alloys remains unexplored. In this study, we prepared Ti6Al4V- x WC (wt%) (x = 0, 10, 20) coatings on Ti6Al4V substrates using laser melting deposition, specifically examining the effects of WC content on the microstructure and properties of the coating. The experimental findings indicate that the introduction of WC particles resulted in the formation of a TiC reinforced phase within the composite coating which promoted the equiaxialization of lamellae α phase. The hardness of the coatings increased significantly with the increase of the mass fraction of WC nanoparticles. Notably, the Ti6Al4V-10WC and Ti6Al4V-20WC coatings exhibited wear resistance that was 2.5 and 3.4 times greater, respectively, compared to the Ti6Al4V coatings. This enhancement in wear resistance can be attributed to the reinforcing phase (TiC) formed by the addition of WC. This experiment demonstrates a viable approach to improving the wear resistance of the Ti6Al4V titanium alloy through surface treatment.
materials science, multidisciplinary,metallurgy & metallurgical engineering, characterization & testing