Abstract:This paper focuses on the strengthening study of the latent heat thermal energy storage (LHTES) unit and proposes a coupling strengthening method with non-uniform graded metal foam and active rotation. The non-uniform graded metal foams are employed to enhance heat conduction, and the rotation method is selected to make full use of natural convection. The solidification and melting behavior under the coupling effect of non-uniform metal foam and active rotation are numerically analyzed. The aluminum foam is partially concentrated and divided into two parts (concentrated part and diluted part) and is divided into the even-layered or uneven-layered porous structures according to the different regions area. Under the same volume of phase change material (PCM), the effects of layered forms (even-layered and uneven-layered approach), concentrated porosity, concentrated ratio, and rotational speed are performed. It can be concluded that the metal foam should concentrated near the inner tube and the uneven-layered structure can further improve the phase change heat transfer performance compared to the even-layered structure. Moreover, the thermal performance of the LHTES unit improves firstly and then decreases as the concentrated porosity, concentrated ratio, and rotational speed increase. The optimal values are obtained at 0.86 concentrated porosity, 0.3 concentrated ratio, and 0.5 rpm rotational speed. Compared with the static case with uniform metal foam, the melting time, solidification time, and total melting and solidification time can be significantly reduced by 40.30 %, 28.66 %, and 33.18 %, respectively. Similarly, the thermal energy storage rate can be correspondingly increased by 62.57 %, 40.82 %, and 54.11 %, respectively.

Study on heat transfer process in ice storage ball filled with metal foams

Experimental Research on Low Supercooling of Ice Storage and Analysis of Its Energy Saving

Numerical Analysis of Heat Transfer Behaviours of Melting Process for Ice Thermal Storage Based on Various Heat Source Configurations

Experimental Study On Heat Transfer Characteristics Of Conductive Plastic Ice-On-Coil

Study on the effect of partial filling of foam metal on the solidification performance of ice storage spheres

Solidification performance enhancement of encapsulated ice storage system by fins and copper foam

Numerical research on the solidification heat transfer characteristics of ice thermal storage device based on a compact multichannel flat tube-closed rectangular fin heat exchanger

Numerical and optimization study on heat storage and release process of novel fin-metal foam composite structures under periodic heat source

Effect of compact fin structure on heat transfer performance of ice storage unit during freezing

Design and operating evaluation of a finned shell-and-tube thermal energy storage unit filled with metal foam

Role of copper foam on solidification performance of ice-cool storage sphere system

Solidification of an annular finned tube ice storage unit

Design and assessments on graded metal foam in heat storage tank: An experimental and numerical study

Thermal management of cold storage unit in existence of nano-sized additive using Galerkin method

Numerical study of solidification and melting behavior of the thermal energy storage system with non-uniform metal foam and active rotation

Comparative study on heat transfer enhancement of metal foam and fins in a shell-and-tube latent heat thermal energy storage unit

Thermal characteristics of conical heat storage tank filled by metal foam: Optimization by response surface analysis

Design and study of metal foam parameters on whole melting-solidification cycle in phase change heat storage system

Effect of fin-metal foam structure on thermal energy storage: An experimental study

Numerical Analysis on a Latent Thermal Energy Storage System with Phase Change Materials and Aluminum Foam

Experimental and Numerical Studies on Melting/solidification of PCM in a Horizontal Tank Filled with Graded Metal Foam