Abstract:The development of sensitive fiber-optic accelerometers is a subject of continuing interest. To acquire high resolution, Michelson phase interferometric techniques are widely adopted. Among the variety structures, the compliant cylinder approach is particularly attractive due to its high sensitivity that is defined as the induced phase shift per applied acceleration. While the two arms of Michelson interferometer should be at the same optical path, it is inconvenient to adjust the two arms' length to equal, also the polarization instability and phase random drift will cause a signal decline. To overcome these limitations, a novel optical fiber accelerometer based on differential interferometric techniques is proposed and investigated. The interferometer is a Sagnac-like white light interferometer, which means the bandwidth of laser spectrum can be as wide as tens nanometers. This interferometer was firstly reported by Levin in 1990s. Lights are divided to two paths before entering the coupler. To induce time difference, one passes through a delay arm and another goes a direct arm. After modulated by the sensing component, they reflect to opposite arm. The sensing part is formed by a seismic mass that is held to only one compliant cylinder, where the single-mode optical fiber is wrapped tightly. When sticking to vibrations, the cylinder compresses or stretches as a spring. The corresponding changes in cylinder circumference lead to strain in the sensing fibers, which is detected as an optical phase shift by the interferometer. The lights from two arms reach the vibration source at different time, sensing a different accelerate speed; produce a different optic path difference. Integrating the dissimilarity of the accelerated speed by time can obtain the total acceleration graph. A shaker's vibration has been tested by the proposed accelerometer referring to a standard piezoelectric accelerometer. A 99.8% linearity of the optical phase shift to the ground acceleration is achieved. The acceleration sensitivity is 300 rad/g. It proves to have a simple structure, good practice, reliable measurement and stable performance.

Research on an optimized optical fiber accelerometer for well logging

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Research On Accelerometer Based On Multi-Mode Interference

Design of a practical intensity modulated dynamic optical fiber accelerometer

Design and Modification of a High-Resolution Optical Interferometer Accelerometer

3-component fiber optic accelerometer for well logging

A Novel Differential Optical Fiber Accelerometer

A 3-Component Fiber Optic Accelerometer for Well Logging

Frequency Response Optimization of Optical Fiber Acceleration Sensor Based on Compliant Cylinder

Analysis of the Mechanics and Deformation Characteristics of Optical Fiber Acceleration Sensor

Compact Fiber Optic Accelerometer

Design, Simulation and Optimisation of a Fibre-optic 3D Accelerometer

Study on Miniature Fiber Optic Accelerometer System

Analysis of the natural frequency and phase sensitivity of an optical fiber accelerometer coated with a rigid package

Optimal design of high sensitive integrated optical accelerometer

Medium-High Frequency and High Sensitivity Fiber Optic Acceleration Sensor Based on F-P Interference

A New Fiber Optic Accelerometer Based on Fiber Bragg Grating

Low-Cost Fiber Optic Cantilever Accelerometer with a Spherical Tip Based on Gaussian Beam Focusing

Theoretical Model and Design of Highly Sensitive Reflective Fiber Optic Fabry-Pérot Cavity Accelerometer Independent of Fiber Stiffness

A Novel Optical Accelerometer Based on Slant-Ended Fiber

Broadband Optomechanical Accelerometer Reaching the Thermomechanical Limit Based on Suspended Si3N4 Membrane Resonator