Abstract:MoO3/gamma-Al2O3, MoO3/TiO2 and MoO3/SiO2 samples prepared by impregnation method have been studied by various techniques, including XPS, XRD, and extraction of molybdenum with ammonium solution or water. The result of extraction of molybdenum with ammonium solution shows that if the MoO3 content is lower than certain amount, a constant fraction (71% for MoO3/gamma-Al2O3 system and 66% for MoO3/TiO2 system) of MoO3 can be dissolved in 3wt.% solution of NH4OH and if the MoO3 content is higher than that amount, surplus MoO3 can be dissolved completly. The turning point of both systems is in line with the dispersed threshold value obtained by XPS and XRD methods. It means that MoO3 disperses as monolayer on these carriers before the turning point and forms crystallite grain after that. The constant dissolved fraction of MoO3 in ammonium solution shows that there are two different surface species in monolayer state, one is soluble and another is not. Two kinds of species coexist in monolayer With constant ratio, which have also been confirmed by XPS experiment for samples before and after extraction. The samples which soluble species was thoroughly removed were recalcined at certain temperture and again soaked into ammonium solution a lot of soluble species were reproduced then. The dissolved fraction of them approched that of the samples before extraction with a rise in temperature and a prolonging of time. We suggest that the monolayer dispersed MoO3 on gamma-Al2O3 or TiO2 surface can be divided into two kinds of surface species, one is located in octahedral vacancy of O-2- and another in tetrahedra vacancy. They join each other by sharing oxygen ions and form monolayer aggregate patch in a special way (similar to gamma-molybdena MoO4). It is a thermodynamic favorable state in both systems. For MoO3/SoO(2) samples, however, the situation is quite different. All of MoO3 species in the monolayer iis soluble thoroughly in ammonium solution. It shows that the mutual interaction between MoO3 in monolayer state and the surface of SiO2 carrier is mach weaker than that of two other systems.

STUDIES ON WO3/ZRO2 AND MOO3/ZRO2 SOLID SUPERACID SYSTEMS

Raman Spectroscopy Studies on the Structure of Moo3/Zro2 Solid Superacid

Study on MoO3/ZrO2 Solid Superacid

Phase Behaviors of the Zrmo2-Xwxo8 (X=0.2-2.0) System and the Preparation of an Mo-Rich Cubic Phase

Studies on SO<sub>4</sub><sup>2−</sup> promoted mixed oxide superacids

Studies on SO 4 2− promoted mixed oxide superacids

Structure Characterization Of Wo3/Zro2 Catalysts By Raman Spectroscopy

The Effect of the Preparation Methods on the Structure of Wo3/Zro7

Study on the Extraction of Molybdenum and Surface State for Moo3 Supported on the Surface of Gamma-Al2o3, Tio2 and Sio2

Raman spectroscopic studies on tetragonal supportedZrO 2 MoO 3 and systemsZnO – MoO 3

Determination of the maximum monolayer dispersion and dispersed state for WO3 on γ-Al2O3

Effect of B-site Ion Substitution on Chemical Bond Characteristics and Microwave Dielectric Properties of ZnWO4 Ceramics

Spectroscopic Studies on Tetragonal ZrO2-supported MoO3 and NiO−MoO3 Systems

Investigation of the Dispersion of MoO3 Onto the Support of Mesoporous Silica MCM-41

Effect of thermal treatment time on the dispersion of MoO3 onto the surface of MCM-41

Preparation of MoO 3 powder by hydrothermal method

Sol-gel synthesis and characterization of tungsten-molybdenum solid solution nanoparticles

A Comparative Study on the Dispersion Behaviors and Surface Acid Properties of Molybdena on CeO2 and ZrO2 (Tet)

A study on the monolayer dispersion of tungsten oxide on anatase

Acid Properties of WOx/t-ZrO2 under Hydrothermal Environments: A Periodic DFT Study

EXAFS Study of Molybdenum Oxide on the Structure Al2O3