Abstract:In the circulating fluidized bed (CFB), the non-uniform mesoscale structure formed by the particle clustering effect causes a substantial decrease in the gas-solid drag. Since the degree of particle clustering varies with operating conditions, an accurate drag model needs to be universal in different heterogeneous flow conditions. In this study, the relationships between the Ψ factor in clusters' solid holdup model that characterizes the flow non-uniformity and the operating parameters of CFB (including slip velocity Reynolds number, Re*, bed-averaged solid volume fraction, εs,bed, and solid mass circulation rate, Gs) are established. It improves the adaptability of the QC-EMMS drag model under different working conditions. In previous research, we established two types of models that related Ψ factor to Re* and εs,bed respectively. However, there exists a problem of high dispersion of points, indicating that the selected parameters cannot fully describe the flow non-uniformity. Therefore, Gs is reintroduced to modify the two types of models. The results show that the prediction accuracy of the modified models is improved and the relative error is <10%, indicating that the non-uniform factor Ψ has a strong correlation with Gs. In addition, the quantitative relation between Re*, εs,bed, and Gs is derived from modified models, and the trend of relation is highly consistent with the fluidization diagram proposed by Yerushalmi J., which verifies the accuracy of modified models. Finally, numerical simulation of typical CFB cases proves the adaptability of the modified models in wide operating conditions of fluidization.

Cluster identification criterion with experimental validation for the cluster solid holdup model during fluidization

Novel Phase Inversion Model for Gas–solid Turbulent Fluidized Beds

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Research Progress in Numerical Models on Gas-Solid Fluidization of Cohesive Particles

Identification and Dynamic Properties of Clusters for Geldart Group B Particles in a Circulating Fluidized Bed

Study on the Numerical Model of Gas-Liquid Dispersion Driven by a Coaxial Mixer

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

Numerical studies of the influence of particles' size distribution characteristics on the gravity separation performance of Liquid-solid Fluidized Bed Separator

Evolution and Fluidization Behaviors of Wet Agglomerates Based on Formation-Fragmentation Competition Mechanism

Characterization of Flow Pattern of Cohesive Particles in Gas-Solid Fluidized Bed Via Axial Distribution of Particle Motions

Development and Validation of Cluster and EMMS Drag Model

Particle‐level dynamics of clusters: Experiments in a gas‐fluidized bed

Non-intrusive Characterisation of Particle Cluster Behaviours in a Riser Through Electrostatic and Vibration Sensing

CFD-DEM Simulation of Clustering Phenomena in Riser and Downer

Coupling particle image velocimetry and digital image analysis to characterize cluster dynamics in a fast fluidized bed

Study on the Numerical Model of Dense Solid Suspension Driven by a Coaxial Mixer

Clustering in Gas-Fluidized Riser Flows of Flexible Fibers

Experimental study of dynamic characteristics of solid holdup fluctuations in a gas-solid cyclone reactor

A CFD–DEM study of the cluster behavior in riser and downer reactors

Investigation of cluster property in the riser of circulating fluidized bed with a wide particle size distribution

Research on the Generalization Issue of the Heterogeneous QC-EMMS Drag Model for Gas-Solid Fluidization