Abstract:This study attempts to clarify the correlation between the structural parameters of vortex finders (diameter ratio and insertion depth) and the strong turbulent flow field and performance of cyclone separators. To elucidate the effects due to the overflow pipe diameter, insertion depth, and Reynolds number on the tangential velocity index (n) and separation efficiency, 0.3D, 0.4D, 0.5D, 0.6D, and 0.7D (where D is the diameter of the cyclone separator’s cylindrical section) were selected as the vortex finder diameter and insertion depth, which were studied using three methods: computational fluid dynamics (CFD) software Fluent, experiments, and artificial neural network simulations. With Fluent, the Reynolds stress model (RSM) of turbulence was adopted to describe transport equations, and the discrete phase model (DPM) for two-phase flow was used to calculate the efficiency and separate particles at different inlet velocities. Experiments were conducted to measure the operational pressure drop and separation efficiency of the system; subsequently, the results were used to validate the CFD calculation results. Finally, a 5–5-1 three-layer artificial neural network was established based on 336 sets of data for values of n obtained from numerical simulations. In addition, a backpropagation (BP) artificial neural network model was employed to predict the correlation between the structural and operational parameters of the cyclone separator and n values. The obtained results indicate that the BP artificial neural network can accurately predict the distribution of n values within the flow field of the cyclone. Increasing the diameter of the vortex finder with the same inlet velocity can reduce the total pressure drop due to the cyclone, thereby reducing the kinetic energy loss and improving the separation efficiency of fine particles. Increasing the insertion depth of the vortex finder leads to an increase in the values of n. Considering the stability of the flow field structure and energy dissipation, an S/D value between 0.5 and 0.6 is preferred.

Effects of Different Inlet Structures on the Flow Field of Cyclone Separators

Numerical Simulation of Three Dimensional Gas-Particle Flow in a Spiral Cyclone

A study on gas flow in spiral inlet cyclone separator

Numerical Simulation of Three-Dimension Flow Field in a New-Type Cyclone Separator with a Radial Inlet Structure

Influence of Depth-width Ratio of Inlet Section on Flow Field in Cyclone Separator

Effect of inlet periodic velocity on the performance of standard cyclone separators

Effects of the inlet particle spatial distribution on the performance of a gas-solid cyclone separator

Experimental study on the intensive swirling flows in a cyclone section

Numerical Simulating the Gas-solid Flow in Square Cyclone With a Curved Inlet

Numerical study of gas-solid flow in a radial-inlet structure cyclone separator

Simulation and experimental study of effect of vortex finder structural parameters on cyclone separator performance

Effects of Diameter Parameters on Gas Flow Field Characteristics in Cyclones: An Experimental Investigation

Numerical investigation of hydrocyclone inlet configurations for improving separation performance

CFD Simulation Study on Particle Arrangements at the Entrance to a Swirling Flow Field for Improving the Separation Efficiency of Cyclones

3D turbulent flow modeling in the separation column of a circumfluent cyclone

Experimental study on the gas-solid two-phase flow in a square cyclone separator with downward gas exit by particle dynamic analyzer

AN EXPERIMENTAL STUDY ON THE GAS-SOLID TWO-PHASE FLOW IN A SQUARE CYCLONE SEPARATOR WITH DOWNWARD GAS EXIT BY 3D-PDA

Performance analysis of multi-inlet cyclone separators considering different shapes and locations of the inlet ducts

Study on Inner Vortex in a Hydrocyclone Through Numerical Simulation

3-D Flow Characteristics Of Asymmetric Vortices Over An Ogive-Cylinder And Its Structural Model

Numerical simulation of gas-solid flow in a cyclone separator with additional inlet