Abstract:Thermal management has become one of the critical problems in high-power laser systems. The laser crystal, which dissipates a heat flux over 150 W/cm2, is the most challenging component when solving the thermal problem. In this work, a specialized central-jetting microchannel heat sink (MCHS) is proposed purposely for a small-size laser crystal with high heat fluxes. Considering the space constraint and installation restriction, the MCHS has a narrow width to fit with the laser crystal, while its length is extended to enhance the heat dissipation capability. The MCHS is integrated by welding the two layers completely through a vacuum brazing method. Central-jetting impingement is introduced to enhance the cooling efficiency. Coolant is flushed vertically into the microchannel layer toward the central heating region where the heating source is attached at the central bottom of the MCHS. We conduct a parametric study on the thermal performance of the MCHS by experiments. The overall heat transfer coefficient of the MCHS achieves 50 × 103 W/(m2•K), and the average heat transfer coefficient of the microchannel reaches 21.5 × 103 W/(m2•K). The surface temperature of the heating head is controlled below 65 °C, and the temperature variation is less than 5 °C. In the solid bottom of the MCHS, thermal resistance in vertical direction is over 1.8 times of that in the horizontal direction, ensuring an efficient heat dissipation in the extended volume. The local heat transfer characteristics are further examined through additional numerical simulations. The wall temperature of the microchannel and the local heat transfer coefficient have a high plateau in the heating region, and then drop significantly along the flow direction. Due to heat transfer enhancement by jet impingement, the heat transfer coefficient in the central region is generally 15% higher than that averaged on the full microchannel.

Numerical Research on Microchannel Cooling Structure of High Power Solid-State Lasers

Modeling of Kinetic and Thermodynamic Processes in a Flowing Exciplex Pumped Alkali Vapor Laser

Theoretical Analysis of Thermal-Lensing Effect in a High Power Exciplex Pumped Cs Vapor Laser.

Theoretical Investigation on Exciplex Pumped Alkali Vapor Lasers with Sonic-Level Gas Flow

Thermal Effects in High-Power Double Diode-End-Pumped Cs Vapor Lasers

Numerical analysis of the cooling structure of side-pumped solid laser

Study on Hydrodynamic Effects in Longitudinal Forced Convection for High Power Laser Amplifier

Study on Temperature Distribution of Disk-Type Laser Based on Heat-Fluid-Solid Multiphysics Coupling Method

Experimental study on spray cooling for high-power laser

Design And Simulation Of Locally Enhanced Microchannel Heat Sink For Diode Partially Pumped Slab Laser

Thermal performance of a central-jetting microchannel heat sink designed for a high-power laser crystal

Simulations of Temperature in Disk-Type Laser with Fluid–Solid Interaction

Study on Thermal Effects of LD End-Pumped High-Repetition-rate Nd:YAG Laser

Analysis on Temperature Field of Laser Crystal in a Super High Power Solid-State Laser

Numerical simulation of the cooling capacity of heat sink with high heat flow density

Computational Study and Optimization of Laminar Heat Transfer and Pressure Loss of Double-Layer Microchannels for Chip Liquid Cooling

Structural Optimization of a Microjet Based Cooling System for High Power LEDs

The Effect of Geometric Parameters on Flow and Heat Transfer Characteristics of a Double-Layer Microchannel Heat Sink for High-Power Diode Laser

Evaluation of thermally-induced lens of a pentagonal-side-pumped solid-state laser rod

Temperature and Thermal Stress Distribution in Thin Disk Laser End-Pumped by LD

Optimization design of microchannel heat sink geometry for high power laser mirror