Vacancy-induced resistive switching and synaptic behavior in flexible BST@Cf memristor crossbars

Ze Wang,Jianling Yue,Chao Jiang,Isaac Abrahams,Yantao Yu,Yunxin Li,Zuojuan Du,Xiaozhong Huang,Linling Li,Guangyuan Wang,Hao Zhou

DOI: https://doi.org/10.1016/j.ceramint.2020.05.262

IF: 5.532

2020-01-01

Ceramics International

Abstract:In this study, carbon fibers (C-f) coated with Ba0.6Sr0.4TiO3 (BST) (BST@C-f) were prepared by magnetron sputtering and subsequently heated in nitrogen to produce oxygen vacancies. BST@C-f and nitrogen-treated BST@C-f were cross-stacked on polyimide (PI) film to make a BST@C-f memristor. The electrical properties of BST@C-f memristor were measured after being bent 3000 times. The device exhibits bipolar figure-of-eight (f8) hysteresis loop characteristics under applied voltage. The hysteresis loops narrow with increasing temperature of heat treatment in nitrogen, due to decrease in oxygen vacancy concentration. The hysteresis loops demonstrate the switching process of resistance between high resistance state (HRS) and low resistance state (LRS), with a maximum HRS/LRS ratio of 10(6). The switching process can be divided into two parts, corresponding to Schottky Emission and Fowler-Nordheim (F-N) Tunneling. It is notable that no electroforming voltage is required to stimulate the memristor. The constructed memristor was cycled successfully 1000 times and retained the LRS 787 s during power cut off. In addition, the device exhibited synaptic behavior including learning and forgetting processes, in accordance with the paired-pulse facilitation (PPF) rule. The use of BST@C-f in the construction of the nonvolatile memristor imparts flexibility to the device allowing for the possibility of wearable flexible intelligent memristor based electronic devices in the future.