Abstract:To reveal the strength and stiffness characteristics of Kapton foils in detail, axial and off-axial tensile tests were conducted systematically. First, Kapton foils with a thickness of 25 μm were used, and the strip specimens were manufactured according to the machine direction (MD) and the transverse direction (TD) of the foils. The stress–strain curves of the foils were obtained under five constant strain rates (10, 25, 50, 100, and 200 mm/min). Based on the stress–strain curves, the tensile strength, elongation at break, equivalent yielding stress, yielding strain and elastic modulus were analyzed and calculated. Based on the results and analysis, some useful findings were derived. The stress–strain curves showed obvious nonlinearity; and there were at most four main stages of approximate elasticity, elasticity-plasticity, plastic flow and strain hardening from the beginning of tension to fracture. The uniaxial tensile mechanical properties of the Kapton foils along the MD and TD are almost identical during the approximate elasticity stage. After that stage, the material showed different mechanical properties in the two directions. By analyzing the mechanical parameters above, quadratic or linear fitting formulas with the tensile rate as the variable were given, which can be used to predict the mechanical parameters of Kapton foils under different strain rates and provide basic data for inflatable deployable structures in the future. Second, for the same samples as above, the tensile tests of seven off-axis angles from 0° to 90° with a step size of 15° were conducted. Based on the obtained stress–strain curves, strength and elongation at break under different angles, the relationships between the elastic modulus and strain were deduced. The results show that Kapton is a typical type of nonlinear and anisotropic material. Additionally, there is an "N"-shaped relationship between the tensile strength and off-axis angles, which is different from the "U"-shaped relationship embodied in the Tsai-Hill strength criterion. The elastic modulus of Kapton foils varies as the off-axis angle changes. The elastic theory of orthotropic plates provides a good prediction of the equivalent elastic modulus of Kapton foils. The results can provide some basic references for the strength prediction, deformation calculation, and design and analysis of inflatable deployable structures.

Tensile properties of orthodontic elastic modules

[Comparison of Mechanical Properties on Different Phase Transformation Points of Nickel-Titanium Orthodontic Wires].

Finite element analysis and experimental study of spiral flexure spring

Comparative study on measuring method for initial extension force of elastomeric auxiliaries for use in orthodontics

Novel Ring Compression Test Method to Determine the Stress-Strain Relations and Mechanical Properties of Metallic Materials

Experimental research on uniaxial tensile mechanical properties of Kapton foils

Measurement Study for Elastic Modulus of Metal Wires

STUDIES ON TENSILE PROPERTIES OF BRAIDED STRUCTURAL COMPOSITE MATERIALS

Fabrication of Apparatus Specialized for Measuring the Elasticity of Perioral Tissues

The Eulerian buckling test for orthodontic wires

THREE DIMENSIONAL MECHANICAL ANALYSIS FOR THE ORTHODONTIC FORCES OF ORTHODONTIC WIRES

The influence of autoclave sterilization on elastic module and flexural strength of five types of posts

Bending Property Analysis and Experimental Study of Orthodontic Wires

Comparisons of nanoindentation, 3-point bending, and tension tests for orthodontic wires

A study of the load-deflection rate of multiloop edgewise arch(MEAW) and the superelastic nickel-titanium wire

EXPERIMENTAL RESEARCH AND THEORETICAL ANALYSIS ON FLEXURAL BEHAVIOR OF HIGH-STRENGTH CONCRETE-FILLED SQUARE AND RECTANGULAR STEEL TUBES

Experiment and Analysis of Uniaxial Tensile Mechanical Properties of ECTFE Foils Under Different Strain Rates

Mechanical properties analysis of medical endodontic instruments based on parameterization

Validation of a Double-Semicircular Notched Configuration for Mechanical Testing of Orthodontic Thermoplastic Aligner Materials

Simulation Analysis of Equibiaxial Tension Tests for Rubber-like Materials

Tests of Buckling-Restrained Braces Using Low-Yield Point Steel As Core Material