Damage and Fracture Behavior of Rock

Hang Lin,Ri-hong Cao,Xiang Fan,Yixian Wang

DOI: https://doi.org/10.1155/2019/8476537

IF: 1.843

2019-01-01

Advances in Civil Engineering

Abstract:Underground excavation will lead to stress redistribution, and stress redistribution will also cause the stress of surrounding rock near the excavation area to increase several times or even tens of times [1,2].en, stresses easily exceed the microcrack initiation stress level inside the rock mass.Increased stress in surrounding rock can easily induce brittle failure of rock mass, and the existing literature also shows that brittle failure is a typical failure form of deep well engineering rock mass.At the same time, a large number of engineering practices show that deep ground pressure disasters such as rock burst, floor lag water inrush, and roof fall are all caused by crack propagation and connection in rock mass [3].In fact, the sudden change of instability of deep well rock mass is the result of crack initiation, propagation, and macroscopic failure surface formation.erefore, rock fracturing is also the starting point of disaster breeding in deep rock engineering.As far as the characteristics of rock mass are concerned, it is not isotropic material.After hundreds of millions of years of geological action, there are a large number of discontinuities in its interior.Discontinuities weaken the basic mechanical properties of rock mass to a great extent.However, after excavation, the effect of high stress makes the tip of primary crack in a state of high stress concentration, which is easy to induce crack initiation and propagation damage.e nonlinear deformation behavior of geotechnical materials is induced by the propagation and coalescence of cracks and joints under external loads [4][5][6]; hence, the mechanical characteristics and failure patterns of the rock