Abstract:The deformation-induced surface roughening of an Al-Mg alloy is analyzed using a combination of experiments and modeling. A mesoscale oligocrystal of AA5052-O, obtained by recrystallization annealing and subsequent thickness reduction by machining, that contains approx. 40 grains is subjected to uniaxial tension. The specimen contains one layer of grains through the thickness. A laser confocal microscope is used to measure the surface topography of the deformed specimen. A finite element model with realistic (non-columnar) shapes of the grains based on a pair of Electron Back-Scatter Diffraction (EBSD) scans of a given specimen is constructed using a custom-developed shape interpolation procedure. A Crystal Plasticity Finite Element (CPFE) framework is then applied to the voxel model of the tension test of the oligocrystal. The unknown material parameters are determined inversely using an efficient, custom-built optimizer. Predictions of the deformed shape of the specimen, surface topography, evolution of the average roughness with straining and texture evolution are compared to experiments. The model reproduces the averaged features of the problem, while missing some local details. As an additional verification of the CPFE model, the statistics of surface roughening are analyzed by simulating uniaxial tension of an AA5052-O polycrystal and comparing it to experiments. The averaged predictions are found to be in good agreement with the experimentally observed trends. Finally, using the same polycrystalline specimen, texture–morphology relations are discovered, using a symbolic Monte Carlo approach. Simple relations between the Schmid factor and roughness can be inferred purely from the experiments. Novelties of this work include: realistic 3D shapes of the grains; efficient and accurate identification of material parameters instead of manual tuning; a fully analytical Jacobian for the crystal plasticity model with quadratic convergence; novel texture–morphology relations for polycrystal.

Non‐Destructive Surface Energy Measurements on (1 0 0) Galfenol

Understanding Strong Magnetostriction in Fe100−xGax Alloys

Micromagnetics of Galfenol

Mechanical behavior and auxetic properties of galfenol

The Surface Tension of Ga2O3 Melt Measured by a Drop-Weight Method in an Optical Floating-Zone Furnace

Atomic-scale insights into ω-variants in Galfenol triggered by displacive-diffusive transformation

Improved magnetostriction in Galfenol alloys by aligning crystal growth direction along easy magnetization axis

Microstructural-Based Measurement of Local Stored Energy Variations in Deformed Metals

Tailoring the magnetic properties of galfenol film grown on single-crystal diamond

Temperature‐Dependent Surface Anisotropy in (110) Epitaxial Rare Earth Iron Garnet Films

Mechanism of Large Magnetostriction of Galfenol

Deformation-Induced Surface Roughening of an Aluminum–Magnesium Alloy: Experimental Characterization and Crystal Plasticity Modeling

First-principles Investigation of the Effect of Substitution and Surface Adsorption on the Magnetostrictive Performance of Fe-Ga Alloys

Surface structures of the magnetostrictive D03-Fe3Ga(001)

Fabrication of Single-Crystalline CoCrFeNi Thin Films by DC Magnetron Sputtering: A Route to Surface Studies of High-Entropy Alloys

Magnetoelastic Auxetic‐like Behavior in Galfenol: Experimental Data and Simulations

Retaining the (001) Orientation from Initial Columnar Grains and Magnetostriction in Binary Fe-Ga Alloy Sheets

Clean and As-Covered Zinc-Blende GaN (001) Surfaces: Novel Surface Structures and Surfactant Behavior

First-principles investigation of the effect of substitution and surface adsorption on magnetostrictive properties of Fe-Ga alloys

Finite-temperature surface elasticity of crystalline solids

Atomistic study of intermetallics of Fe-Al-Zn system and their interfacial properties