Abstract:The influence of stress ratio ( R- ratio) and overload effect on the mixed mode fatigue crack growth (FCG) behaviour is experimentally assessed in this study. Mixed-mode FCG tests were conducted on EA4T steel, involving variations in R -ratios, overload types, and overload interval (OLI) cycle times. The results showed that the crack propagation prediction model, incorporating plasticity and roughness-induced crack closure effects as proposed in previous work based on the model of Christopher and Pokluda et al., outperforms four traditional models when fitting experimental data under different R- ratio conditions. Considering the impact of the R- ratio, the original mixed model was modified which shows an improvement of approximately 7 % in fitting experimental data. The ranking of overload retardation effects within overload types was as follows: single overload (SOL) > double overload (DOL) > multiple overload (MOL). The interval cycles incorporated within the overload sequence can weaken the crack closure effect caused by the crack tip overload. A smaller OLI can lead to the retardation effect of the preceding overload being overshadowed by the influence of the subsequent overload, thus diminishing the retardation effect. Increasing the OLI reduces interference among the retardation effects of different overloads, resulting in smaller interference zones for each overload retardation effect. The crack tip opening displacement was proposed as the delay parameter, and the rationality of the delay parameter was verified by combining it with the test data. The parameter effectively reflects the retardation state and aligns well with the test results

Effect of Load Ratio on Fatigue Crack Growth in the Near-Threshold Regime: A Literature Review, and a Combined Crack Closure and Driving Force Approach

Component Structural Equivalent Research Based on Different Failure Strength Criterions and the Theory of Critical Distance

Crack Closure Behavior at Fatigue Crack Growth under Negative Stress Ratio

A Simple Engineering Approach in the Prediction of the Effect of Stress Ratio on Fatigue Threshold

Effect of stress ratio and overload on mixed-mode crack propagation behaviour of EA4T steel

Effect of loading conditions on short fatigue crack propagation behaviours in cast Al Si alloys

A Study on Fatigue Crack Closure Associated with the Growth of Long Crack in a New Titanium Alloy

Fatigue Crack Growth for Ferritic Steel under Negative Stress Ratio

A Novel Method for Characterizing the Fatigue Crack Propagation of Steel Via the Weak Magnetic Effect

Effect of stress ratio on near-threshold propagation of delimination fatigue cracks in unidirectional CFRP

Fatigue crack growth under mixed mode I-II loading with a single tensile overload at negative load ratios

Near-tip Strain Evolution and Crack Closure of Growing Fatigue Crack under a Single Tensile Overload

Effect of Load Ratio on Fatigue Crack Growth Behavior of SS316LN using Two-Parameter (ΔK and Kmax) Model

Experimental and numerical investigation on fatigue crack growth behavior of commercial pure titanium under I-II mixed mode loading at negative load ratios

Numerical investigation of mechanical behavior of crack tip under mode I and mixed-mode I-II fatigue loading at negative load ratios

Evaluation Method of Fatigue Crack Growth Rates at Various Stress Rations. Investigation Based on Small Crack Growth Law.

A modification to the two driving forces model for fatigue threshold prediction

A NOVEL PARAMETER FOR EVALUATING THE FATIGUE CRACK GROWTH RATE IN CARBON STEELS

Cyclic cohesive zone model damage parameter acquisition for fatigue crack growth considering crack closure effect

Mixed-mode I&II fatigue crack growth behaviors of 16MND5 steel: The role of crack driving forces and crack closure

A modified formula for cyclic compression crack growth model considering compressive load effect