Abstract:The modification of eutectic silicon plays a crucial role in enhancing the mechanical properties of hypoeutectic Al-Si alloys. However, there is still limited understanding regarding the factors that affect the modification of eutectic silicon in hypoeutectic Al-Si alloys, particularly in terms of the role played by alloying elements during the modification process. In order to address this gap, this study aimed to investigate the influence of two key alloying elements, Mg and Cu, on the modification effect of Sr. To achieve this, the morphology of eutectic silicon in the as-cast and heat-treated states of Al-7Si alloy, modified with Sr, was examined using scanning electron microscopy (SEM). Different levels of magnesium and copper content were used to analyze their impact on the modification effect of Sr. The results obtained from the analysis revealed that both Mg and Cu significantly weaken the modification effect of strontium on eutectic silicon. Furthermore, it was observed that the degree of deterioration in the modification effect increases progressively with higher alloying element content. Interestingly, increasing the strontium content and adjusting the cooling rate were found to be ineffective in eliminating this weakening effect caused by Mg and Cu. These findings highlight the complex interplay between alloying elements and the modification process of eutectic silicon in hypoeutectic Al-Si alloys. A deeper understanding of these factors is essential for the development of effective strategies to optimize the mechanical properties of such alloys.

Eutectic Nucleation in Al-7 Wt Pct Si-Mg Casting Alloys

Kinetic Nucleation of Primary Α(al) Dendrites in Al–7%Si–Mg Cast Alloys with Ce and Sr Additions

Eutectic Solidification in Near-eutectic Al-Si Casting Alloys

Modifying Agent Selection for Al-7Si Alloy by Miedema Model

Study on mechanism of refining and modifying in Al-Si-Mg casting alloys with adding rare earth cerium

Effect of Ca Addition on Solidification Microstructure of Hypoeutectic Al-Si Casting Alloys

Effect of rare earth Ce on the microstructure and mechanical properties of cast Al–7Si alloys

Refining Mechanism and Elevated-Temperature Mechanical Properties of Al-Ce Alloys Solidified under Super Gravity Field

Effect of Alloying Elements Mg and Cu on the Modification of Eutectic Silicon in Hypoeutectic Al-Si Alloys

Refinement of eutectic grains/cells in near-eutectic Al-Si alloys

Study on the Eutectic Modification Level of Al–7Si Alloy by Computer Aided Recognition of Thermal Analysis Cooling Curves

Effect of Sc and Sr on the Eutectic Si Morphology and Tensile Properties of Al-Si-Mg Alloy

Modification of Eutectic Silicon in Al-Si Cast Alloys

Nanoparticle-Induced Nucleation of Eutectic Silicon in Hypoeutectic Al-Si Alloy

Synergistic Effects of Ce and Mg on the Microstructure and Tensile Properties of Al-7Si-0.3Mg-0.2Fe Alloy

Effect of Scandium on Grain refinement mechanism and Mechanical Properties of Al-7Si-0.6Mg alloy at Different Cooling Rates

Combined Treatment of Sr and B and Evaluation of Refinment-Modification Levels for Al-7si Casting Alloy

New Method of Eutectic Silicon Modification in Cast Al–Si Alloys

Eutectic Growth in Sr Modified Al–13%Si Alloy under Unidirectional Solidification

Influence of Alloying Element Mg on Na and Sr Modifying Al-7Si Hypoeutectic Alloy

Solidification behaviour of Al-7%Si-Mg casting alloys