Abstract:The thermal deformation behavior of a novel TG6 titanium alloy from 850 to 1050 °C with a strain rate of 0.001-10 s−1 was studied using a Gleeble-3500 thermal simulation compressor. The constitutive model was established, then metallography was used to observe the evolution of microstructure under the influence of temperature or deformation rate, the evolution of α/β phase, and the angular distribution of grain boundaries during thermal deformation were described with the help of EBSD. The results after comprehensive analysis are as follows: TG6 titanium alloy is a strain rate and temperature-sensitive material, the flow stress increases with an increase in strain rate when the temperature is stable, and the flow stress decreases with increasing temperature at a stable strain rate. Furthermore, the flow stress increases rapidly with increase in strain in the initial stage of deformation; after reaching the maximum, it begins to decrease slowly until a relatively stable state. The morphology, size, and content of the phase can be affected by the deformation temperature and strain rate to a certain extent. The elongation and distortion of the α phase occur as the temperature falls below 950 °C and the strain rate increases above 0.01 s−1; besides, as the temperature rises near the phase transition point, the primary α phase begins to dissolve, the acicular α phase gradually precipitates from the coarse β phase and tends to continue coarsening. Finally, the combination of EBSD analysis and 3D hot processing map reveals that the dynamic recrystallization behavior is more evident at low temperatures and strain rates.

The different deformation behaviors of the two types of gamma hydrides in pure titanium under cyclic straining

The Deformation Behaviors of Gamma Hydrides in Titanium under Cyclic Straining

Tensile and Low-Cycle Fatigue Behaviors of Commercially Pure Titanium Containing Γ Hydrides

An Investigation on Structure, Deformation and Fracture of Hydrides in Titanium with a Large Range of Hydrogen Contents

In-situ synchrotron-based high energy X-ray diffraction study of the deformation mechanism of δ-hydrides in a commercially pure titanium

Microstructure of Cyclically Deformed Titanium with Low Hydrogen Concentration I. Crystal Rotation and Formation of Cell Structure Near Hydrides

In-situ synchrotron based high energy X-ray diffraction study of the deformation mechanism of δ-hydride in a commercially pure titanium

Dislocation Interaction with Hydrides in Titanium Containing A Low Hydrogen Concentration

Effect of pre-deformation on hydrogen diffusion and hydrogen induced damage in commercially pure titanium

Constitutive Model and Microstructure Evolution of a Novel TG6 High-Temperature Titanium Alloy during Hot Deformation

Face-centered tetragonal titanium hydrides in fine-grained commercial pure (grade 2) titanium

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

Plastic Deformation Mechanism and Slip Transmission Behavior of Commercially Pure Ti during In Situ Tensile Deformation

Tensile Deformation Behavior of Coarse-Grained Ti-55 Titanium Alloy with Different Hydrogen Additions

Hydride precipitation dependence on α-parent orientation and plastic deformation in zirconium alloys

Characterizing solute hydrogen and hydrides in pure and alloyed titanium at the atomic scale

Microstructures with Martensitic Features Induced by Absorption of a Large Amount of Hydrogen in a B2 Single-Phase Ti-22Al-27Nb Alloy

Hydrogen Diffusion-Induced Crystallographic Changes in Α Plus Β Titanium Alloy

The Microstructures and Deformation Mechanism of Hetero-Structured Pure Ti under High Strain Rates

Structure and mobility of -type screw dislocation in presence of H in α-Ti from first-principles

Compressive deformation behaviors of coarse- and ultrafine-grained pure titanium at different temperatures: A comparative study