Abstract:In this paper a novel nondestructive strategy is proposed for distinguishing differences between a stress corrosion crack (SCC) and a fatigue crack (FC) based on signals from eddy current testing (ECT). The strategy consists of measurement procedures with a special ECT probe and crack type judgment scheme based on an index parameter that is defined as the amplitude ratio of the measured signals. An ECT probe, which can induce eddy current flowing mainly in a selected direction, is proposed and applied to detect crack signals by scanning along the crack with different probe orientations. It is clear that the ratio of the amplitudes of signals detected for parallel and perpendicular probe orientations is sensitive to the microstructure of the crack, i.e., the parameter is much bigger for a fatigue crack than that of a SCC Therefore, whether a crack is a SCC or a FC can be recognized nondestructively by comparing the index parameter with a threshold value that can be previously determined. In order to verify the validity of the proposed strategy, many artificial SCC and FC test pieces were fabricated and ECT inspections were performed to measure the corresponding crack signals. Numerical simulations were also conducted to investigate the physical principles of the new methodology. From both the numerical and experimental results, it is demonstrated that the strategy is very promising for the distinction of artificial SCC and FC; there is also good possibility that this method can be applied to natural cracks if the threshold value can be properly determined.

Quantitative Evaluation of Electrical Conductivity Inside Stress Corrosion Crack with Electromagnetic NDE Methods

Assessment of Local Conductivity Distribution in Stress Corrosion Crack Region Using Direct Current Potential Drop Method

Study on Conductivity of Stress Corrosion Crack by Using Eddy Current Testing

Quantitative evaluation of stress corrosion cracking based on crack conductivity model and intelligent algorithm from eddy current testing signals

Reconstruction of Stress Corrosion Cracks Using Signals of Pulsed Eddy Current Testing

Study on the Conductivity Model of SCC by Using a New Eddy Current Probe

Analysis of Magnetic Flux Perturbation Due to Conductivity Variation in Equivalent Stress-Corrosion Crack

Based on a Regularization Method Using Multi-Frequency Ed

A Numerical Study on Eddy Current Signal Characteristics of Imitative Stress Corrosion Cracks

Reconstruction of Stress Corrosion Cracking Using Multi-Frequency Eddy Current Testing Signals Based on Genetic Algorithm

A Nondestructive Strategy for the Distinction of Natural Fatigue and Stress Corrosion Cracks Based on Signals from Eddy Current Testing

Reconstruction of deep stress corrosion crack based on a multi-objective optimization evaluation from Eddy Current Testing signals

Reconstruction of Stress Corrosion Cracks Based on Pulsed Eddy Current Signals

Quantitative Nondestructive Estimation of Deep Defects in Conductive Structures

Sizing of volumetric stress corrosion crack from eddy current testing signals with consideration of crack width

Influence of the Online Closure Loading on the Eddy Current Testing Signals of Closed Fatigue Crack

Reconstruction of Stress Corrosion Cracks Using High-Dimension Hybrid Optimization Algorithm from Eddy Current Signals

Reconstruction of Cracks in a Carbon Fiber-Reinforced Polymer Laminate Plate from Signals of Eddy Current Testing

A multiple frequency strategy for reconstruction of stress corrosion crack from ECT signals

A Study on Influence of Plastic Deformation on the Global Conductivity and Permeability of Carbon Steel

Nondestructive Eddy Current Array (ECA) Technique for Stress Corrosion Cracking (SCC) Detection and Assessment