Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

Influence of the Seed Layer on Photoactivity Inhibition of Mica–titania Pigments

Effect of Sn4+ Doping on the Photoactivity Inhibition and Near Infrared Reflectance Property of Mica-Titania Pigments for a Solar Reflective Coating

Effect of seed layer on optical properties and visible photoresponse of ZnO/Cu 2 O composite thin films

Effect of ZnS Layers on Optical Properties of Prepared CdS/TiO2 Nanotube Arrays for Photocatalyst

Synthesis of Mn-intercalated Layered Titanate by Exfoliation–flocculation Approach and Its Efficient Photocatalytic Activity under Visible–light

Visible-light photocatalytic activity of Sn2+-doped TiO2 and its loading effect on mesoporous montmorillonite

A Facile Method of Preparing Sandwich Layered TiO2 in Between Montmorillonite Sheets and Its Enhanced UV-light Photocatalytic Activity

Photodegradation of an Azo Dye Using Immobilized Nanoparticles of TiO2 Supported by Natural Porous Mineral.

Effect of Natural Zeolite Supports for Photoactive TiO2 During the Photodegradation Process

Effect of titanium dioxide (TiO2) seed layer on the phase composition of 0.7Pb (Mg1/3Nb2/3)O3-0.3PbTiO3 film prepared by pulsed laser deposition

Effect of the P/Ti Ratio on the Visible-Light Photocatalytic Activity of P-Doped Tio2

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

Influence of TiO 2 Seeding Layers on Phase Composition of Lead Magnesium Niobate-Lead Titanate Thin Films Prepared by RF Magnetron Sputtering

Photo-catalytic activity of Fe3+/Sn4+ co-doped titanium dioxide nano-crystalline thin films for methyl orange degradation

Structural Analysis and Characterization of Doped Spinel Co2−xMxTiO4 (m=mg2+, Mn2+, Ni2+, Cu2+ and Zn2+) Coated Mica Composite Pigments

Preparation and Phase Transformation of Anatase–rutile Crystals in Metal Doped TiO2/muscovite Nanocomposites

Photo-Catalytic Activity of Fe3+/Sn4+Co-Doped Titanium Dioxide Nano-Crystalline Thin Films for Methyl Orange Degradation

Preparation and photocatalytic activity of ZnO/TiO2/SnO2 mixture

Phase structure, surface properties and photocatalytic activity of Zn2+- doped TiO2 nanopowders

Effect of TiO2 on the crystallization of mica glass-ceramics

Structural limiting factors of mixed-valent tin oxides in photoelectrochemical application: A comparative exploration