Abstract:Weakly agglomerated nanocrystalline scandia doped tin oxide powders with high surface area (170−220 m2/g) and uniform size (3−4 nm) were synthesized for the first time by a two-step hydrothermal process in the presence of urea, followed by the calcination between 500 and 1200 °C. The structure and texture of the binary oxide system were characterized by thermogravimetry and differential thermal analysis, Brunauer−Emmett−Teller-specific surface area analysis, transmission electron microscopy, X-ray diffraction, Raman spectroscopy, and X-ray photoelectron spectroscopy. A metastable scandium tin oxide solid solution in tetragonal structure was formed for the scandia content lower than 6 mol % as the samples were calcined at 800 °C, and the excess Sc atoms were dispersed at the surface of the crystallites above this limit. The solid solution was metastable, so scandium migrated toward the surface region of the crystallites and produced a second phase of Sc4Sn3O12 during calcining at high temperatures over 1000−1200 °C. In the case of the samples with higher dopant concentration (>15 mol %), the calcination at the temperature between 500 and 800 °C caused the precipitation of Sc2O3, and the calcination over 1000−1200 °C led to the formation of more Sc4Sn3O12. Textural analysis showed that doping an appropriate amount of Sc2O3 into nanosized SnO2 could effectively inhibit the grain growth and stabilize the surface area against high-temperature calcinations below 1000 °C. CO gas-sensing property measurements revealed that the dispersion of Sc at the surfaces of the SnO2 nanocrystallites could improve the CO sensitivity significantly, and the pellet sample with scandia content of 10 mol % sintered at 800 °C showed the best CO gas-sensing property in the operation temperature range of 300−400 °C. On the basis of the structural and textural analysis, the correlation between the structure/texture and the sensitivity to CO for the as-calcined (SnO2)1-x(Sc2O3)x nanocrystallites has been established and explained.

AC impedance studies of SnO2 : Sc2O3 based CO sensor

Improved Sensitivity of α-Fe2O3 Nanoparticle-Decorated ZnO Nanowire Gas Sensor for CO

SnO2 Highly Sensitive CO Gas Sensor Based on Quasi-Molecular-Imprinting Mechanism Design

Enhanced gas-sensing performance of SnO2/Nb2O5 hybrid nanowires

The Effect of Multiwalled Carbon Nanotube Doping on the CO Gas Sensitivity of SnO2-based Nanomaterials

Synthesis, Structure, Texture, and CO Sensing Behavior of Nanocrystalline Tin Oxide Doped with Scandia

Investigation of a Planar Electrochemical Carbon Monoxide Sensor Using AC Impedance Spectroscopy

The effects of crystallite growth and dopant migration on the carbon monoxide sensing characteristics of nanocrystalline tin oxide based sensor materials

In-situ Synthesized N-doped ZnO for Enhanced CO2 Sensing: Experiments and DFT Calculations

ZnO Based Ultrasensitive CO Chemiresistive Gas Sensor

Simple Synthesis of Cuo Nanosheets with Exposed (111) Active Crystal Facets and Oxygen Defects for Co Detection at Room Temperature

Gas Sensing Properties of Co3O4-loaded SnO2 to Ethanol and Acetone

Gas Sensing Property and Microstructure of SnO2 Nanocrystalline Prepared by Solid State Reaction—thermal Oxidation

Low concentration CO gas sensor constructed from MoS2 nanosheets dispersed SnO2 nanoparticles at room temperature under UV light

Stability and Sensitivity in CO Detection

A computational study on the Al-doped CuO nanocluster for CO gas sensor applications

CuO surface doped In2O3/CeO2 nanofibers for ppb-ppm level carbon monoxide gas detection in low-temperature

High-Performance Conductometric Acetone Gas Sensor Based on Co3O4/ZnO Nanorods with Abundant Oxygen Vacancies

High Response CO Sensor Based on a Polyaniline/SnO2 Nanocomposite

Synthesis, characterizations and improved gas-sensing performance of SnO2 nanospike arrays

Selective detection of trace carbon monoxide at room temperature based on CuO nanosheets exposed to (111) crystal facets