Abstract:It is significant for circuit breakers to expel a short-circuit fault in a short time for the new power grid with high proportional photovoltaic or wind power plants to achieve high transient operating stability. Compared with a traditional circuit breaker, a fast vacuum circuit breaker (FVCB), operated by an electromagnetic repulsion actuator, has an extremely shorter opening time and lower deviation in their opening times. This potentially contributes the FVCBs to interrupting a short-circuit fault current in the first half-wave when introducing a controlled switching technology. Meanwhile, it is beneficial to improve the short-circuit current breaking capacity of the FVCBs by adopting series-connected double-break circuit breaker technologies. This paper aims to explore short-circuit current interruption characteristics of a double-break FVCB within the minimum arcing time. We performed a series of short-circuit current interruption tests in a Weil synthetic test circuit. Two seriesconnected FVCBs and independent single-break FVCBs were used. Three different kinds of opening velocities were adopted for each of the FVCBs. Results showed that the increase in opening velocity resulted in both a decrease in the minimum arcing time and the critical arc extinguishing contact gap, whether for the single-break or the double-break interruption tests. The ratio of the shared voltage on each of the series-connected FVCBs was about 54 (for the break on the high-voltage side) and 9 (for the break on the low-voltage side). Taking the break with a shorter opening time as a break in the high-voltage side could reduce the minimum arcing time and the critical arc extinguishing contact gap. At the same opening velocity, the sum of the critical arc extinguishing contact gap of the two breaks in double-break interruption tests was significantly higher than twice the critical arc extinguishing contact gap in the single-break interruption tests. This could be caused by the fact that in double-break interruption tests, after the breakdown of one break, even if the break restored insulation, could not share the transient recovery voltage (TRV) before the break broke down. In addition, the sudden drop of TRV without breakdown occurred for the break on the high-voltage side might correlate with the micro-discharge of the vacuum gap. The interaction of the charged particles with the electrode surface would be responsible for the formation and evolution of the micro-discharge in some successful interruption cases.

Experiment Researches on Cold State Dielectric Recovery Characteristics in High Voltage SF6 Circuit Breakers

Study on the Dielectric Recovery Performance of High Voltage SF6 Circuit Breaker

Study on the Mathematical Model of Dielectric Recovery Characteristics in High Voltage SF6Circuit Breaker

Analysis of the Dielectric Breakdown Characteristics for a 252-Kv Gas Circuit Breaker

Dynamic Dielectric Strength of C 3 F 7 CN/CO 2 and C 3 F 7 CN/N 2 Gas Mixtures in High Voltage Circuit Breakers

Simulation Research on the Post-arc Dielectric Recovery Characteristics of Multi-break Vacuum Circuit Breakers

An Approach for Minimum Percussion Welding in Closing Operation of a 126-Kv Vacuum Circuit Breaker

Application of arc breaking simulation in development of extra high voltage SF<sub>6</sub> circuit breaker

Researches on dielectric recovery characteristics of CO<inf>2</inf> gas-blast arc chamber under no-load breaking

Study on the Influence of Speed in DRM of SF6 Circuit Breaker

Influence of no-load operation and current switching on breakdown characteristics of high voltage vacuum interrupters at contact gap 30mm

Fundamental tests for 550 kV SF6 synchronous circuit breaker

Study on Short-circuit current interruption characteristics of Double-break fast vacuum circuit breaker within the minimum arcing time

Study on Breaking Characteristics of SF<sub>6</sub>/N<sub>2</sub> Gas Mixtures GIS Disconnecting Switch

Experimental study on characteristics of co 2 and its gas mixtures with sf 6 for high voltage gas circuit breakers

Study on the Influencing Factors of Reignition Characteristics for 40.5kv Vacuum Circuit Breakers

Research on Dielectric Recovery Characteristic after Large Capacity DC Interruption

Influence of PTFE Vapor on Dielectric Breakdown Property of Hot SF6 Gas

Study On The Breakdown Characteristics Of Sf6 Gas In Quasi-Uniform Field Under Impact Voltage

Experimental Study on Arc Interruption Characteristics of SF6 and Its Mixtures With CF4

Hump Phenomena and Mechanism of SF6 Gas Discharge Under Impulse Voltages