Abstract:Silicon photomultipliers (SiPM) are rapidly adapted in simultaneous time of flight (TOF) PET and MRI imaging system in recent years due to its fast timing response and immunity to magnetic field. The aim of this work is to develop multi-channel fast SiPM readout electronics for clinical TOF PET detector. The detector module is assembled by directly coupling a 12x12 LYSO crystal block to an 8x8 Sensl FB30035 SiPM array. We are developing two approaches of compact readout electronics to handle the large number of SiPM output channels. One is a low noise and high bandwidth, 128-channel ASIC to readout the 64 fast outputs and 64 standard outputs of the 8x8 SiPM array. The other approach is a conventional electronics based multiplexing readout scheme using discrete components. A charge division resistor network reduced 64 channels of standard output to four energy signals, and multiplexing and summing circuits reduced 64 channels of fast output to one timing signal, making the detector block highly compact and scalable. The ASIC design has been finished and it's ready for tape-out. Preliminary performance of the detector module readout by conventional electronics was evaluated. 12x12 LYSO crystals were well resolved and identified in the flood image and the average energy resolution was 15.6% +/- 1.3%. For single crystal pair, 240ps coincidence resolving timing (CRT) was achieved. It was dropped down to 500ps for detector block to single crystal configuration, due to the combination effects of: 1) degradation of fast signal rising edge by output capacitance addition of SiPMs and 2) large white electronic noise and ultrahigh dark count rate. The readout design will be further optimized by increasing the signal bandwidth and reducing noise to get better timing performance at a cost of increasing circuit complexity to a reasonable level. The performance of ASIC readout will be evaluated and good timing performance is expected due to the individual pixel timing pick-off.

P P-1 7 ) 0 3 0 KLauS 4 : A Multi-Channel SiPM Charge Readout 1 ASIC in 0 . 18 μ m UMC CMOS Technology

A Low-power ASIC with Row-column Summing Structure for 64-Channel SiPM Readout

A Highly Linear FPGA-Based TDC and a Low-Power Multichannel Readout ASIC with a Shared SAR ADC for SiPM Detectors

Development of a Multi-Channel ASIC with Individual Energy and Timing Digitization for SiPM Detectors for TOF-PET Applications

A Mixed-Signal Micromegas Readout ASIC Prototype With Automatic Charge Measurement Range Calibration

CLARO-CMOS, a very low power ASIC for fast photon counting with pixellated photodetectors

A multichannel front end ASIC for PMT readout in LHAASO WCDA

Development of an Eight-Channel Time-Based Readout Asic for Pet Applications

An Analogue Front-End ASIC Prototype Designed For PMT Signal Readout

The Development of a Readout ASIC for TPC Based X-ray Polarimeter

Development Of A Multi-Energy Photon-Counting Readout Asic For Czt Detectors

Development of a Pixel Readout ASIC for CZT Detectors for Spectral X-ray Photon-Counting Imaging Applications

On-Chip Fast Signal Generation and Low-Power SAR ADC for SiPM Readout

The SparkPix-S ASIC for the sparsified readout of 1 MHz frame-rate X-ray cameras at LCLS-II: pixel design and simulation results

A 12-bit 30 MS/s SAR ADC in 180 nm CMOS for PMT signal readout

DIET: a multi-channel SiPM readout ASIC for TOF-PET with individual energy and timing digitizer

Development Of A Low Noise Readout Asic For Czt Detectors For Gamma-Ray Spectroscopy Applications

Evaluation of the KLauS ASIC at low temperature

Development of a Low Power and High Integration Readout ASIC for Time Projection Chambers in 65 Nm CMOS

Development Of Multi-Channel Fast Sipm Readout Electronics For Clinical Tof Pet Detector

A High-Speed Low-Noise Front-End ASIC Prototype for Ionization Chambers of High-Intensity Beam Monitoring