Abstract:Preparation of mullite from high-alumina coal fly ash (CFA) has become one of the most important ways for high-value utilization. However, low Al2O3/SiO2 ratio, poor reaction activity and various impurities in fly ash led to poor quality of mullite products. Conventional sintering method requires addition of aluminum sources and sintering additives, and high synthesis temperature. This paper proposes a new technical route for preparation of mullite whiskers entirely from fly ash by molten salt method based on additive activation-acid leaching process. The growth process and synthesis mechanism of mullite whiskers in Na2SO4 molten salt from fly ash were systematically investigated, and the application of fly ash-derived mullite whiskers in electronic packaging toughening ceramic was also explored. The results show that leaching liquor containing Al3+, Na+, and SO42−, and amorphous silica slag can be separated and obtained after acid leaching of activated fly ash at 80 °C, and the fly ash-derived mullite whiskers with a length of about 1 μm can be synthesized from the mixture of crystalline products and silica slag by the proposed method under the optimal synthesis conditions. Using amorphous silica slag with higher dissolution activity as the silicon source, the nucleation of mullite whiskers with homogeneous nucleation process is promoted and highly monodispersed mullite whiskers derived from fly ash form. The fly ash-derived mullite whiskers can improve the mechanical strength, reduce the dielectric constant and dielectric loss of the composite ceramic substrates, and the dielectric constant and dielectric loss of the composite ceramic are the lowest 5.16 and 0.006, respectively, when the mullite addition content is 20 wt.%, indicating that they could be used as electronic packaging materials. This paper provides a novel pathway for synthesis of mullite whiskers and high-value utilization of fly ash.

Preparation of Mullite Ceramics from Coal Fly Ash by Deep-desilication Technology

Preparation of Fly Ash-Based Porous Ceramic with Alumina as the Pore-Forming Agent

Preparation of High Performance Mullite Ceramics from High-Aluminum Fly Ash by an Effective Method

Preparation of low-cost mullite ceramics from natural bauxite and industrial waste fly ash

Preparation of porous mullite ceramic supports from high alumina fly ash

Dilithium Dialuminium Trisilicate Crystalline Phase Prepared from Coal Fly Ash

Preparation of Mullite Nanocomposites Powders from Coal Fly Ash Via Hydrothermal Crystallization

Effect of V2O5 on the Properties of Mullite Ceramics Synthesized from High-Aluminum Fly Ash and Bauxite

The Preparation of Mullite Nanocomposites Powders from Silicon-Aluminium- Bearing Minerals Through Hydrothermal Crystallization

A clean and efficient utilization of fly ash with a focus on the strengthening decomposition mechanism of mullite

Synthesis of Mullite Using Low-Grade Bauxite and Coal Gangue

Effect of Silicon Source (Fly Ash, Silica Dust, Gangue) on the Preparation of Porous Mullite Ceramics from Aluminum Dross

Fabrication of Al<sub>2</sub>O<sub>3</sub>-SiC-Mullite Composites from Fly Ash

Preparation Of Mullite Ceramics With Fly Ash And Clay By Pickling Process

Molten Salt Synthesis of Mullite Whiskers Entirely Derived from Fly Ash for Electronic Packaging Toughening Ceramic Applications

Experimental Study on the Mullite-SiC Composite Materials From Fly Ash

Recycling of Fly Ash for Preparing Porous Mullite Membrane Supports with Titania Addition

Alumina Extraction from Alumina Rich Fly Ash Generated from Inner-Mongolia Chinese Coal

Influence of MgO on Properties and Microstructure of Mullite Ceramics Synthesized from Coal Fly Ash

Effects of Sodium Carbonate and Sodium Chloride Additives on Alkaline Fusion of Coal Fly Ash

Extraction of Aluminum Hydroxide from Coal Fly Ash by Pre-Desilication and Calcination Methods