Effect of applied stresses on signals EMSPEC and 3 MA systems based on magnetic behaviour of steel

P. Meilland,A. J. Peyton,R. Schmidt,F. D. van den Berg,H. Yang

2018-01-01

Abstract:EMspec and 3MA magnetic based systems are promising for contactless on-line assessment of strip properties at e.g. the run-out table after hot rolling, the exit of continuous annealing and galvanizing lines. However, interpreting the system output signals in relation to the strip properties is not straightforward due to a number of complexities, of which the presence of low level stresses is of fundamental importance. Indeed the stress level and moreover its orientation may have an impact on measurements which can be detrimental to the link with microstructure properties. This results from the direct impact of applied stresses on the magnetic B-H hysteresis cycle of the material, which has been studied for electrical Fe-Si laminations:  Low level tension applied parallel to the magnetic field has low impact on the magnetic hysteresis loop, only rendering it slightly softer;  Oppositely, compression applied parallel to the magnetic field dramatically impacts the B-H hysteresis loop, increasing the coercive field, diminishing its dB/dH slope, and slightly bulging the curve around the coercive field. As EMspec and 3MA do not directly display the B-H loop, the effect of stresses will have a different reading. To identify these figures of merit, a specific test rig was assembled and a set of industrial samples was carefully selected. Experiments allowed the measurement of EMspec and 3MA output sensitivities to applied stress. Applying magnetizing field in different directions allowed indirect identification of the effect of compressive stresses. For the first time, the known effects of stresses on the hysteretic B-H loops could be transposed to the 3MA and EMspec signals. Such an analysis allows in particular identifying the presence of residual compressive stresses in one of the samples.