Abstract:An SMA (shape memory alloy) is a functional material with a unique property known as the shape memory effect, or superelasticity. Microscopically, the mechanical actuation of this effect is based on reversible transformation between different crystal phases. To clarify the atomistic mechanism in SMA, we perform molecular dynamics simulation (MDS) of phase transformations for a Ni-Ti alloy, a typical alloy used for engineering SMAs. EAM potential, which can produce both B2 and B19' structures (stable crystal phases of Ni-Ti), is adopted to model the interatomic interaction of the nickel and titanium atomic systems. Two different-sized MDS models are constructed with unit cell structures of B2 phase. These structures are surrounded by free surfaces and constrained regions so as to be subjected to uniaxial tensile loading. A series of reversible processes likely to occur in SMA, including loading, unloading, heating, and cooling, is reproduced by corresponding stages of the MDS. Phase transformation is thought to be observable by detecting the local interatomic distances and bonding angles peculiar to B19' structure (martensite). During tensile loading simulations, the martensite crystal structure is always observed, having transformed from the B2 structure. At a large strain, models exhibit a rapid propagation of local lattice distortions accompanied by the formation of martensite. In unloading simulations, the larger model contains relatively less martensite than the smaller model. The discrepancy with regards to model size may depend on a different degree of constraint strength. Reverse transformation (from B19' to B2) occurs mainly in the subsequent heating stage, in which the stress is observed to increase under constant residual strain.

Observation for Proportion of Super-elastic Martensitic Transformation in Cu-Al-Ni Shape Memory Alloy with AE Simulation

Modulus Softening During the Γ→ɛ Martensitic Transformation in Fe–25Mn–6Si–5Cr–0.14N Alloys

Dynamic Behavior Evaluation of Martensitic Transformation in Cu-Al-Ni Shape Memory Alloy Using Acoustic Emission Simulation by FEM

Direct observation of hierarchical nucleation of martensite and size-dependent superelasticity in shape memory alloys.

Microstructure, Martensitic Transformation And Superelasticity Of T1(49) (6)N1(45 1)Cu(5)Cr(0 3) Shape Memory Alloy

In-situ TOF Neutron Diffraction Studies of Cyclic Softening in Superelasticity of a NiFeGaCo Shape Memory Alloy

Fem Analysis of Localized Deformation Behaviour in Pseudoelastic Niti Shape Memory Alloys

In Situ Observation of Thermoelastic Martensitic Transformation of Cu-Al-Mn Cryogenic Shape Memory Alloy with Compressive Stress

Effects of Ecae and Aging on Phase Transformations and Superelasticity of A Ni-Rich Tini Sma

Microstructure, Martensitic Transformation and Superelasticity of Ti49.6Ni45.1Cu5Cr0.3 Shape Memory Alloy

Rate dependent damping of single crystal CuAlNi shape memory alloy

Numerical Study on Mechanical Response of Superelastic NiTi Shape Memory Alloy under Various Loading Conditions

Local Mechanical Response of Superelastic NiTi Shape-Memory Alloy Under Uniaxial Loading

Experimental Investigation on Rate Dependence of Thermomechanical Response in Superelastic NiTi Shape Memory Alloy

Structural and Phase Transformations and Physical and Mechanical Properties of Cu-Al-Ni Shape Memory Alloys Subjected to Severe Plastic Deformation and Annealing

Influence of Isothermal Treatment on Superelastic Behavior of Cu-13.8al-4.0ni(Mass Fraction) Single Crystals

Mechanism of Stress Induced γ→ε Martensite Transformation in an Fe-Mn-Si Shape Memory Alloy

Observation of Phase Transformation and Structural Analysis for Ni-Ti Alloy by Molecular Dynamics Simulation

Experimental Investigation on the Mechanical Instability of Superelastic NiTi Shape Memory Alloy

Experimental Observations on Mechanical Response of Three-Phase Niti Shape Memory Alloy under Uniaxial Tension

Influence of Α′ Martensite on Shape Memory Effect in Fe-14Mn-5Si-9Cr-5Ni Alloy