Abstract:Interphase drag coefficient is a critical input in two-fluid model (TFM) and discrete particle method (DPM). In this study, extensive TFM and DPM simulations were carried out to study of the hydrodynamics of gas-solid flows of monodisperse, rough particles in a dense fluidized bed using fourteen drag coefficient correlations available in literature, the simulation results were then compared to the direct numerical simulation (DNS) and experimental data of Tang et al. (2016). It was shown that (i) all TFM and DPM simulations result in a lower bed expansion rate than those of DNS and experiment, which indicates that the true interphase drag force is underestimated by all fourteen drag coefficient correlations; (ii) all DPM simulations can correctly capture, at least in a qualitative sense, the main hydrodynamic features obtained from DNS, but some TFM simulations with the exactly same drag coefficients show anomalous phenomena. This is not an indicator of the failure of the used drag coefficients but might be a sign of the deficiency of the used particle phase stress model in this specific situation; (iii) the time-averaged differential pressure drops of DPM and TFM simulations agree well with DNS results, but the characteristic frequency of pressure fluctuation found in DNS is overestimated by a factor of 2–3 by all DPM and TFM simulations; and (iv) the magnitude of local and global granular temperatures of TFM, DPM and DNS are all in a fair agreement, but the degree of the anisotropy of both local and global granular temperature found in DNS is systematically underestimated by DPM and TFM, especially, the local granular temperature in TFM simulations is inherently isotropic due to the fundamental assumption of the used kinetic theory. This study highlights the need of a better interphase drag coefficient and a better particle phase stress model for modeling dense gas-solid flow.

Study on drag force coefficients in modeling granular flows in a slot-rectangular spouted bed

A Critical Comparison of Two-Fluid Model, Discrete Particle Method and Direct Numerical Simulation for Modeling Dense Gas-Solid Flow of Rough Spheres

Study on a Semi-Resolved CFD-DEM Method for Rod-Like Particles in a Gas-Solid Fluidized Bed

A Simplified Steady-State Mesoscale Drag Model with an Analytical Solution for Fluidized Beds

Models of Interphase Drag Force from Direct Numerical Simulations of Upward Turbulent Particle-Laden Channel Flows

Comparative analysis on gas–solid drag models in MFIX-DEM simulations of bubbling fluidized bed

CFD-DEM Simulation of Liquid-Solid Fluidized Bed with Dynamic Restitution Coefficient

Evaluation of Drag Force on A Nonuniform Particle Distribution with A Meshless Method

Homogeneous drag models in gas–solid fluidization: Big data analytics and conventional correlation

A Model to Improve Granular Temperature in CFD-DEM Simulations

Numerical study of turbulence model effect on gas-particle flow behavior in spouted bed

Dem Simulation of Wet Granular-Fluid Flows in Spouted Beds: Numerical Studies and Experimental Verifications

Experimental study and transient CFD/DEM simulation in a fluidized bed based on different drag models

Influence of meso-scale structures on drag in gas–solid fluidized beds

Effects of Restitution Coefficient and Drag Force on Gas-solid Flow Behavior: A Two-fluid Model Simulation

Drag coefficient for micron-sized particle in high-speed flows

Drag Force Model Corrections Based on Nonuniform Particle Distributions in Multi-Particle Systems

Heterogeneity Analysis of Gas-Solid Flow Hydrodynamics in a Pilot-Scale Fluidized Bed Reactor

A generalized drag Law for heterogeneous gas-solid flows in fluidized beds

Drag coefficients for elongated/flattened irregular particles based on particle-resolved direct numerical simulation

Modeling of Drag with the Eulerian Approach and EMMS Theory for Heterogeneous Dense Gas–solid Two-Phase Flow