Abstract:It is of significance but still a great challenge to model drag force exerted on particles in dense systems directly from experimental measurements. In this work, a new procedure using inline experimental measurements is developed to establish a total drag model. Specifically, local flow characteristics including slip velocity, particle holdup and particle acceleration are measured simultaneously using an inline vision probe. Then, the total drag coefficient exerted on particles in suspension is calculated using the inline data with the unsteady motion of particles taken into account. At last, the total drag coefficient versus five dimensionless numbers including all important factors are correlated as C D = 3.55 × 10 - 2 ρ r - 1.82 A r 0.53 Re l 0.45 Re - 1.79 α P - 0.49 . Systematically evaluated using the image-based results in this work and PEPT data in the reference as well as Tang model, Gidaspow model and Brucato model popularly used in suspensions, the newly developed model shows some excellent characteristics. (i) It can predict flow field and solid holdup distributions with sufficient accuracy in a wider range of holdups from dilute to dense systems. (ii) Especially, the prediction precision is significantly higher (with deviation of 5.6%) in the holdup distribution compared to Gidaspow model, Brucato model and Tang model. (iii) Furthermore, better mass conservation is always kept during the simulation process compared to the other three models. It is preliminarily inferred that some particles are not fully suspended due to the smaller drag force in the case of Gidaspow model. More studies are still needed to explain quantitatively the above evaluation results.

Evaluation of Drag Force on A Nonuniform Particle Distribution with A Meshless Method

Research Progress in Numerical Models on Gas-Solid Fluidization of Cohesive Particles

Development and Validation of Filtered Drag Models for Fluidization of Low-Density Geldart A Particles

Drag Force Model Corrections Based on Nonuniform Particle Distributions in Multi-Particle Systems

Numerical Simulation of the Accumulation of Heavy Particles in a Circular Bounded Vortex Flow

Analysis and Simulation of Fluid-Particles Interaction with Particle Flow Code

Modeling of Drag with the Eulerian Approach and EMMS Theory for Heterogeneous Dense Gas–solid Two-Phase Flow

Particle-resolved simulation on viscous flow past random and ordered arrays of hot ellipsoidal particles

Study on drag force coefficients in modeling granular flows in a slot-rectangular spouted bed

Two-Fluid Model Simulations of the National Energy Technology Laboratory Bubbling Fluidized Bed Challenge Problem

Evaluation of a Bubble-Structure Dependent Drag Model for the Simulation of Bubbling Fluidization with Geldart A Particles

An approach for drag correction based on the local heterogeneity for gas–solid flows

Homogeneous drag models in gas–solid fluidization: Big data analytics and conventional correlation

Numerical Simulation of Particulate Flows in CFB Riser with Drag Corrections Based on Particle Distribution Characterization

Drag coefficient for micron-sized particle in high-speed flows

Numerical Simulation of Drag on Local Particle Cluster Within a High Void Fraction Environment in Supercritical Water

Research on the Generalization Issue of the Heterogeneous QC-EMMS Drag Model for Gas-Solid Fluidization

Evaluation of the Flow Behavior in a Large-Scale Polydisperse Particle Fluidized System by an Energy Minimization Multiscale-Eulerian Combined Model

Inertial Number-Based Drag Model and Its Application in Simulating the Fluidization of Geldart B and D Particles

Heterogeneity Analysis of Gas-Solid Flow Hydrodynamics in a Pilot-Scale Fluidized Bed Reactor

Modeling total drag force exerted on particles in dense swarm from experimental measurements using an inline image-based method