Abstract:With the increase of magnetic storage density, the thickness of the protective diamond like carbon (DLC) film on the surfaces of head and disk is required as thin as possible. In this paper, the structure, mechanical properties and corrosion and oxidation resistance of ultra-thin DLC films are investigated. The ultra-thin DLC films were deposited by using filtered cathodic vacuum arc (FCVA) technique. The exact thickness of the ultra-thin DLC film was determined by high resolution transmission electron microscope (HRTEM). Raman analysis indicates that the ultra-thin DLC film presents ta-C structure with high sp3 fraction. In the wear test, a diamond tip was used to simulate a single-asperity contact with the film surface and the wear marks were produced on the film surface. The wear depths decrease with film thickness increasing. If the film thickness was 1.4nm or above, the wear depth was much lower than that of Si substrate. This indicates that the ultra-thin DLC film with thickness of 1.4nm shows excellent wear resistance. Corrosion tests in water and oxidation tests in air were carried out to investigate the diffusion barrier effect of the ultra-thin DLC films. The results show that the DLC film with thickness of 1.4nm provides adequate coverage on the substrate and has good corrosion and oxidation resistance.

TuA-2-4 EFFECTS OF ADDITIVES AND DEEP UV IRRADIATION ON MAGNETIC HARD DISK TO WEAR ON MAGNETIC HEAD

Ultraviolet Irradiation of Lubricant and Additives Thin Films to Reduce Wear to the Magnetic Head

A flyability and durability dilemma in hard disk drives

Study on the Cyclotriphosphazene Film on Magnetic Head Surface

Reducing Head Magnetic Spacing of Magnetic Hard Disk and Its Limitations

MoA-2-5 is No Lube Disk Possible?

Improvement of Thermal Stability of the Lubricant Film for the Heat Assisted Magnetic Recording Media

Continuous Ultra-Thin Carbon Nitride Thin Film for Magnetic Hard Disk Via Post Nitrogen Plasma Treatment

Effect of Additives on Tribological Performance of Magnetorheological Fluids

Magnetic field modulated direct overwrite with continuous wave laser irradiation for magnetic-optic disks

Performances of Lubricants in Hard Disk and Their Influences on Dynamic Characteristics of Magnetic Recording System

Magnetic Field Modulated Direct Overwrite on A Magneto-Optical Disk

Formation and Tribology Properties of Polyfluoroalkylmethacrylate Film on the Magnetic Head Surface

A study on the relationship between the magnetic properties of a worn surface layer and the wear resistance

The Protective Properties of Ultra-Thin Diamond Like Carbon Films for High Density Magnetic Storage Devices

Influence of novel additives and antiwear agents on the properties of PAO-based magnetorheological fluids

Microtribology of Hard Disk Drive for High Density Recording

Laser-assisted Mechanical Texturing of Magnetic Media

Study on Tribological Properties of Cadmium Dialkyl-Dithiophosphyl-ldithiophosphate Additive

The antiwear function and mechanism cadmium dialkyldithiophosphate additive

Velocity Dependence of Lifetime and Temperature Rise During Pin-on-Disk Type Sliding Tests on Coated Magnetic Disks