Abstract:Carboxylic acids make up a well-known group of organic friction modifiers (OFMs). OFMs can present different types of polar heads that can eventually lead to different surface adsorption properties and tribological responses. Therefore, the goal of this work is to study the effects of the polar head type on the frictional and wear performances of carboxylic acids in a water-based lubricant. Lauric acid (C12) was chosen as the reference OFM, and methyl laurate and monolaurin were chosen for the comparison. Sliding friction tests were performed on stainless steel against alumina balls under boundary lubricating conditions. The effect of the adsorbed layers and the tribofilm formation was studied by varying the initial maximum hertzian contact pressure, i.e., tests were performed at 1.97 and 0.66 GPa. At the lowest contact pressure, not enough load is applied to obtain enough plastic deformation on the asperity contacts. In this case, a combination of asperity contacts and a thick fluid film formation results in a lack of tribofilm formation, whereas at the highest contact pressure, tribofilms are formed in the asperity contact through tribochemical reactions. Methyl laurate showed no adsorption on the surface, and it was not tested further. C12 and monolaurin showed good adsorption, but the adsorbed layers had different viscoelastic properties. Micro and macrotribological tests showed good frictional behavior for C12 at 0.5 wt % concentration due to the good viscoelastic properties of its adsorbed layer. The adsorbed layer of monolaurin did not show good friction-reducing ability during the micro tribological tests due to its poorer viscoelastic properties. However, the macro tribological tests revealed that monolaurin forms a robust tribofilm protecting the surface from wear and efficiently reducing friction at a concentration of 0.5 wt % resulting in the lowest wear and friction values as observed in this study.

Formation and Tribology Properties of Polyfluoroalkylmethacrylate Film on the Magnetic Head Surface

Research on the Preparation, Characterization and Tribological Properties of Ultra-Thin Self-Assembled Monolayers on the Magnetic Head Surface

Tribological behavior of reciprocating motion between ferromagnetic films coated with polymethylmethacrylate films under magnetic field

Study on the Cyclotriphosphazene Film on Magnetic Head Surface

Comparative Study of the Tribology of Amorphous Carbon Films Via Magnetron Sputtering Depending on the Different Magnetic Field

Preparation and Characterization of Fluoroalkylsilane Self-Assembled Monolayers on Magnetic Head Surfaces

Preparation and Tribological Behaviors of an Amide-Containing Stratified Self-Assembled Monolayers on Silicon Surface

SURFACE MORPHOLOGY AND MICROTRIBOLOGICAL BEHAVIOR OF MAGNETIC VIDEO TAPES

Atomic Force Microscopy of Transfer Film Development

Study on the Properties and Mechanism of m‐FACs/f‐Fe3O4/Epoxy Wear‐Resistant Magnetic Coating

How moisture driven mechanochemistry stabilizes transfer film adhesion and cohesion in ultralow wear PTFE composite

Friction and Wear Behavior of PTFE Coatings Modified with Poly (methyl Methacrylate)

Excellent tribological behavior of hexadecylphosphonic acid films formed on titanium alloy

Effect of the Polar Head Type on the Surface Adsorption and Tribofilm Formation of Organic Friction Modifiers in Water-Based Lubricants

Regulation Mechanism of Special Functional Groups Contained in Polymer Molecular Chains on the Tribological Properties of Modified Ti6Al4V

Effects of Polymer Architecture and Composition on the Adhesion of Poly(tetrafluoroethylene)

Investigation on the microstructural and mechanical properties of a Polytetrafluoroethylene thin film by radio frequency magnetron sputtering

Enhancement of Adhesion by a Transition Layer: Deposition of A-C Film on Ultrahigh Molecular Weight Polyethylene (UHMWPE) by Magnetron Sputtering

Improvement of Thermal Stability of the Lubricant Film for the Heat Assisted Magnetic Recording Media

Atomic-Scale Understanding on the Tribological Behavior of Amorphous Carbon Films under Different Contact Pressures and Surface Textured Shapes

Growth of Self-Assembled Monolayer on Tetrahedral Amorphous Carbon Film Coated Magnetic Head