Abstract:The use of welded I-section steel members with longitudinally profiled (LP) steel plates is becoming popular in structures, and such members are manufactured with variable thickness to accommodate the loading distributions in practical construction. Compared with the constant thickness steel plates, the use of LP steel plates is more susceptible to local buckling at the thinner end. However, there was no study that reported the local buckling behaviour of such members. Furthermore, existing design codes do not provide any design guidance for calculating the strength of such steel members. In this paper, a total of sixteen welded I-shaped section stub columns with LP and constant thickness steel plates under axial compression were tested to study the local buckling behaviour of such members. The initial geometric imperfections of all specimens were measured using 3D laser scanning technology prior to the axial compression experiments. A nonlinear finite element (FE) model was also established, and validated against the corresponding experimental results, which showed a good agreement both in terms of ultimate strength and failure modes. An extensive parametric study including 130 FE models was conducted using validated FE models. To evaluate the feasibility and reliability of the existing design provisions for steel members with constant thickness steel plates, the test and numerical results were compared against design strength predicted from the existing design provisions. Upon comparison, the existing design formulas in Chinese Standard (GB 50017-2017), American Specification (ANSI/AISC 360-10) and European Standard (BS EN 1993-1-5) are found to be generally conservative when calculating the strength of such members with LP steel plates. New design formulas are proposed, in which the modified normalized slenderness ratio and enhancement coefficient are applied to the existing design provisions.

Finite Element Analysis on Bearing Behavior of I-section Beam with Longitudinally Variable Thickness Flanges

Finite element analysis on shear capacity of the corrugated web H-shaped steel beam

Experimental study on deformation performance of I?section beam with longitudinally variable thickness flanges

Theoretical deformation solution of I-section beam with longitudinally variable thickness flanges under single point loading

Elastic Local Buckling and Width-to-Thickness Limits of I-Beams Incorporating Flange–Web Interactions

Design Approach of Stiffeners in Extended End Plate Connections and Finite Element Analysis

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

Effects of End-plate Stiffener on Behavior of Extended End-plate Beam-to-column Connections

Deformation Behavior at SLS of Welded I-section Steel Beams with Longitudinally Profiled Flanges

Flexural Strength and Rotation Capacity of Welded I-section Steel Beams with Longitudinally Profiled Flanges

Behavior of I-section Steel Beam Welding Reinforced While under Load

Experimental Study and Finite Element Analysis on the Local Buckling Behavior of Aluminium Alloy Beams under Concentrated Loads

EXPERIMENTAL INVESTIGATION AND FINITE ELEMENT ANALYSIS OF LOCAL-OVERALL BUCKLING BEHAVIOR OF ALUMINIUM ALLOY BEAMS

Local Buckling Analysis of Aluminum I Section Beams

Analysis of Welding Heat Effect on Load-Carrying Behavior of I Section Steel Beam-Columns Strengthened by Welding

Experimental study on large deflections of beam–column joints with reinforced flange plates

Finite Element Analysis of Bearing Properties of Floor Structure of Precast Cold-Formed Steel Building

NONLINEAR FINITE ELEMENT ANALYSIS OF END-PLATE CONNECTIONS IN STEEL FRAMES

In-plane ultimate load-carrying capacity of tapered I columns

Finite Element Analysis on the Bearing Characters of Arched Variable Cross-Section Gabled Frames Light Steel Structure

Local buckling behaviour of welded I-section steel stub columns with longitudinally profiled steel plates under axial compression: Testing, modelling and design