Abstract:The steel, whose nominal yielding strength f(y) is greater than or equal to 460 MPa, is generally referred to as high strength steel (HSS). Through the comparison with conventional strength steel (CSS) members, HSS members are more vulnerable to local buckling since the component plates are usually designed to be more slender in order to exploit higher material strength. The different mechanical properties between HSS and CSS, including yielding strength, ductility and so on, may lead to different local buckling behavior of steel members. However, little guidance is applicable in existing standards for the stability design of HSS members. In this paper, elaborate finite element (FE) models of HSS welded I-section beams under the loading conditions of uniform moment (four-point loading) and moment gradient (three-point loading) were developed by means of the general-purpose FE software package and validated against the available test results. Continuous lateral supports were ideally applied to restrict the occurrence of coupling with overall lateral-torsional buckling. Comprehensive parametric analyses on key parameters containing the plate width-to-thickness ratio and the steel material properties were further conducted, reflecting the influence of these parameters on the mechanical performance of local stability. Through this work, the variation rules on rotation capacity and postbuckling resistance of HSS welded I-section beams with plate width-to-thickness ratio and steel nominal yielding strength were clarified. Taking into account the interaction of local buckling modes between flanges and webs, new cross-section classification of HSS welded I-section beams was proposed based on the FE analysis results. After the introduction of the concept of interactive local slenderness, the design methods of postbuckling ultimate moment resistance for HSS welded I-section beams subjected to uniform moment and moment gradient were also proposed, which were assessed by comparing the design results with the ones obtained from the corresponding design approaches in Eurocode 3, ANSI/AISC 360-16 and GB 50017-2017. And the reliability of the new proposals was also confirmed by further statistical analysis.

Deformation Behavior at SLS of Welded I-section Steel Beams with Longitudinally Profiled Flanges

Flexural Strength and Rotation Capacity of Welded I-section Steel Beams with Longitudinally Profiled Flanges

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

Theoretical deformation solution of I-section beam with longitudinally variable thickness flanges under single point loading

Elastic Local Buckling and Width-to-Thickness Limits of I-Beams Incorporating Flange–Web Interactions

Experimental study on deformation performance of I?section beam with longitudinally variable thickness flanges

Inelastic Storey-Buckling Factor of Steel Frames

Finite Element Analysis on Bearing Behavior of I-section Beam with Longitudinally Variable Thickness Flanges

Local buckling behaviour of welded I-section steel stub columns with longitudinally profiled steel plates under axial compression: Testing, modelling and design

Behavior of I-section Steel Beam Welding Reinforced While under Load

Structural Behaviour of Improved WUF-B Joints with Longitudinally Profiled Plates

Experimental and numerical investigation on flexural-torsional buckling of Q460 steel beams

Experimental and Analytical Study on Local Buckling Behavior of High Strength Steel Welded I-Section Beams

Lateral-torsional buckling of uniform and tapered welded I-section beams

Investigation of Ductility in Hybrid and High Strength Steel Beams

Design for local buckling behaviour of welded high strength steel I-sections under bending

Postbuckling Resistance of High Strength Steel Welded I-section Beams Based on Interactive Slenderness

Analysis of Welding Heat Effect on Load-Carrying Behavior of I Section Steel Beam-Columns Strengthened by Welding

Global Buckling Behavior of Welded Thick H-Shaped Axial Compression Columns of Q460GJ Steel

Experimental study on large deflections of beam–column joints with reinforced flange plates

Experimental and numerical investigation on Local-Overall interactive buckling behavior of welded I-Section steel columns