Theoretical deformation solution of I-section beam with longitudinally variable thickness flanges under single point loading

Yuanqing Wang,Xiaoling Liu,Yongjiu Shi,Yuyin Wang,Ming Liu,Yi Sui

DOI: https://doi.org/10.11717/j.issn:2095-1922.2016.04.01

2016-01-01

Abstract:I-section beams with longitudinally variable thickness flanges use longitudinally profiled steel plates as flanges. Considering the rigidity difference with normal beam, further study is needed. In this paper, theoretical deformation solution was deduced with the unit load method which based on the principle of virtual work, and the influence of shear deformation was discussed. The finite element models were established, and specific examples were analyzed to verify the correctness of theoretical results. The results show that shear deformation can be reduced, at the same time, under the same bearing capacity, steel dosage could be greatly saved, and this kind of new I-section beam is recommended for the structure optimization design.