Abstract:The use of welded I-section steel members with longitudinally profiled (LP) steel plates is becoming popular in structures, and such members are manufactured with variable thickness to accommodate the loading distributions in practical construction. Compared with the constant thickness steel plates, the use of LP steel plates is more susceptible to local buckling at the thinner end. However, there was no study that reported the local buckling behaviour of such members. Furthermore, existing design codes do not provide any design guidance for calculating the strength of such steel members. In this paper, a total of sixteen welded I-shaped section stub columns with LP and constant thickness steel plates under axial compression were tested to study the local buckling behaviour of such members. The initial geometric imperfections of all specimens were measured using 3D laser scanning technology prior to the axial compression experiments. A nonlinear finite element (FE) model was also established, and validated against the corresponding experimental results, which showed a good agreement both in terms of ultimate strength and failure modes. An extensive parametric study including 130 FE models was conducted using validated FE models. To evaluate the feasibility and reliability of the existing design provisions for steel members with constant thickness steel plates, the test and numerical results were compared against design strength predicted from the existing design provisions. Upon comparison, the existing design formulas in Chinese Standard (GB 50017-2017), American Specification (ANSI/AISC 360-10) and European Standard (BS EN 1993-1-5) are found to be generally conservative when calculating the strength of such members with LP steel plates. New design formulas are proposed, in which the modified normalized slenderness ratio and enhancement coefficient are applied to the existing design provisions.

In-plane ultimate load-carrying capacity of tapered I columns

In-plane ultimate load-carrying capacity of tapered I columns

Experimental Investigation of Circular Steel Tubes with Tapered Ends Subjected to Bending,compression and Torsion

Inelastic Storey-Buckling Factor of Steel Frames

Numerical Investigation and Design of Thin-Walled Complex Section Steel Columns

Ultimate Bearing Capacity of Asymmetrically Double Tapered Steel Columns with Tubular Cross-Section

DIRECT STRENGTH METHOD OF ULTIMATE LOAD-CARRYING CAPACITY OF WELDED BOX-SECTION COLUMNS SUBJECTED TO LOCAL BUCKLING

LOCAL BUCKLING OF THIN-WALLED HIGH STRENGTH STEEL COLUMNS WITH WEB STIFFENERS

RESEARCH ON LOCAL BUCKLING OF DODECAGONAL SECTION DOUBLE SKINNED CONCRETE-FILLED STEEL TUBE SHORT COLUMN

Behavior of Eccentrically Loaded Large-Scale CFST Slender Columns with Latticed Annular Steel

Behaviour of tapered CFDST columns with large hollow ratio under combined loads

Ultimate Compressive Capacity of Tapered Concrete-Filled Double Skin Steel Tubular Stub Columns with Large Hollow Ratio

Experimental Study On The Interactive Buckling Of Welded Section Steel Columns Under Axial Compression

Axial compressive behaviour of tapered CFDST stub columns with large void ratio

Investigation on Buckling Behavior of T-shaped Box-T Section Columns under Axial Load

Local buckling behaviour of welded I-section steel stub columns with longitudinally profiled steel plates under axial compression: Testing, modelling and design

Efficient computation of buckling loads for plane steel frames with tapered members

Analysis and Design Method on Local Buckling Behavior of 960 MPa High Strength Steel Columns under Axial Compression

Ultimate strength of pinned-end dual-angle cross combined section columns under axial compression

FINITE ELEMENT ANALYSIS AND DESIGN METHOD STUDY ON THE LOCAL BUCKLING OF 460 MEGAPASCAL HIGH STRENGTH STEEL I-SECTION COLUMNS UNDER AXIAL COMPRESSION

Study on behavior of slender H-section stub columns subjected to axial compression