Abstract:This paper presents the results of 4 reactor campaigns on the irradiation of biphasic lithium ceramics containing different ratios of lithium orthosilicate (LOS) and lithium metatitanate (LMT) components (25 and 35 mol% LMT in LOS). The size distribution of pebbles in pebble beds was 250-1250 μm and 500-710 μm, respectively. The studies were carried out sequentially with each type of ceramics. In experiments carried out using the vacuum extraction method, the composition of gases released from lithium ceramic samples was registered in in-situ mode. The absence of purge gas during the experiments minimized the possibility of T 2 O and HTO formation, significantly simplifying processing of the results and providing more opportunities for results analysis. The main goal of the present paper was to identify the general patterns of the release of gases with mass numbers M2 (H 2 ), M4 (He + HT), M6 (T 2 ) and M18 (H 2 O) from ceramic samples throughout the entire irradiation experiment in 4 campaigns. Release trends of main gases with mass numbers M2, M4, M6 and M18 for all four campaigns are presented and their comparative analysis was performed. The average partial pressure of tritium release in the form of T 2 and HT molecules for all campaigns was determined as 5.8 · 10 -7 Torr. The dependences of formation rates of helium release peaks on the irradiation time were plotted. The nature of peak emissions does not have a monotonic relationship; upon irradiation, both an increase in the frequency of peaks and a decrease in it are observed. During irradiation, the process of peak helium release does not stop. The simulation was carried out by the finite element method, assuming that tritium release from the sample is determined by diffusion and desorption processes from the sample surface. The experimental curves are satisfactorily described by a number of sets of desorption and diffusion parameters. One way or another they lie in the range of specified values. The Arrhenius dependences of the effective diffusion coefficient and desorption coefficient obtained for lithium ceramics 35 LMT are equal to: D=5,2×10-11m2sexp-21kJmoleRT, K=1.21×10-4m2sexp-64kJmoleRT. The values of the effective diffusion coefficient and tritium desorption coefficient in 25 LMT ceramics were 15 and 20% lower than in 35 LMT ceramics.

Experimental Measurements for the Effective Thermal Conductivity of Pebble Beds with Uncertainty Analysis

Repeatable experimental measurements of effective thermal diffusivity and conductivity of pebble bed under vacuum and helium conditions

Contact Angle Measurement of Molten Lead-Lithium on Silicon Carbide Surfaces

Method and Validation for Measurement of Effective Thermal Diffusivity and Conductivity of Pebble Bed in High Temperature Gas-cooled Reactors

Theoretical Analysis of Effective Thermal Conductivity for the Chinese HTR-PM Heat Transfer Test Facility

Modeling of the Heat Transfer Characteristics of the Effective Thermal Conductivity Test Facility for High Temperature Gas-Cooled Reactors

Experimental Investigation on Contact Angles of Molten Lead–Lithium on Silicon Carbide Surface

Heating system design and validation for the pebble bed effective thermal conductivity experiment in a high temperature gas cooled reactor

Study on Neutronics and Thermo-hydraulics for Mixed Pebble Bed Blanket of Fusion Reactor

Experimental Study of Flow Field Characteristics on Bed Configurations in the Pebble Bed Reactor

Design of the Essential Material Test Equipment for the Pebble Bed Effective Thermal Conductivity Measurement Experiment

Numerical Study of Pebble Recirculation in a Two-Dimensional Pebble Bed of Stationary Atmosphere Using LB-IB-DEM Coupled Method

Data processing method for effective thermal diffusivity experiment of pebble bed in high temperature gas cooled reactors

Molecular dynamics simulations of the effect of porosity on heat transfer in Li2TiO3

A Thermal Resistance Model of Conduction–thermal Radiation Heat Transfer in Pebble-Bed Nuclear Reactors

Comparative analysis of gas release from biphasic lithium ceramics pebble beds of various pebbles sizes and content under neutron irradiation conditions

Design, synthesis and characterization of advanced tritium breeder: Li4Si1-xTixO4 ceramics

Numerical Simulations of the Temperature Field in the Breeding Sub-Module of the ITER Chinese Helium Cooled Solid Breeder Test Blanket Module

Measurement of pressure drop of purge gas flow in unitary and binary pebble beds

Improved Methods for Calculating the Neutron Diffusion Coefficient of General Pebble Bed

Experimental Measurement of Stiffness Coefficient of High-Temperature Graphite Pebble Fuel Elements in Helium at High Temperatures