Abstract:Metal foam heat exchangers have attracted a great deal of interest in numerous engineering fields due to their superior thermal capabilities. In the present study, the heat transfer characteristics of a double-pipe heat exchanger with metal foam insert are numerically investigated. The Forchheimer-extended Darcy equation and the local thermal non-equilibrium (LTNE) model are used to predict the fluid and energy transports, respectively. Thermal resistance of the interface solid wall is considered, while the porous-solid boundary follows the continuity principles. The commercial software FLUENT with specific user defined functions (UDFs) is adopted to implement the simulation. Configurations with uniform foam structure are firstly used to analyze the effects of flow arrangement, foam structural parameters (porosity and pore density) and thermal conductivity on the heat exchanger effectiveness and total pressure drop. Then, graded foam structure along the radius is proposed to further make use of the heat transfer potential of metal foam. The overall thermal performance with increasing and decreasing arrangements of porosity and pore density is assessed. The results indicate that the counter flow shows good performance, with 37.5% higher than the parallel flow in effectiveness. The effectiveness and total pressure drop present monotonic variation with the foam structural parameters for the uniform designs, while maximum performance factor occurs at 15 PPI. The effectiveness has a reduction after gradual increase to a peak 0.89 with the increasing of thermal conductivity of foam matrix. For the designs of graded foam structure, using lower porosity and small pore density at both side of the inner pipe wall shows better overall performance with the performance factors of 4.41 and 4.54.

Performance Evaluation of Metal-Foam Baffle Exhaust Heat Exchanger for Waste Heat Recovery

Numerical Study on Hydrodynamics, Mixing and Heat Transfer of Highly Viscous Fluid in a Novel Shell-and-tube Heat Exchanger with X-type Baffles

Air-side Performance of Open-Cell Metal Foams for Use in Dehumidifying Heat Exchangers

A Comparison of Metal-Foam Heat Exchangers to Compact Multilouver Designs for Air-Side Heat Transfer Applications

Compact Potential of Exhaust Heat Exchangers for Engine Waste Heat Recovery Using Metal Foams

Simulation and Optimization of Metal-Foam Tube Banks for Heat Transfer Enhancement of Exhaust Heat Exchangers

Performance Evaluation of a Double-Pipe Heat Exchanger with Uniform and Graded Metal Foams

Assessment and Optimization of Exhaust Gas Heat Exchanger with Porous Baffles and Porous Fins

Experimental thermal-hydraulic performances of heat exchangers with different baffle patterns

A Study on the Thermal Performance of Heat Exchanger with Trefoil-baffles by Using Unit Duct Model

A Review of Metal Foam and Metal Matrix Composites for Heat Exchangers and Heat Sinks

Numerical Analysis of Forced Convection of High-Temperature Exhaust Gas Around a Metal-Foam Wrapped Cylinder

Study on the thermal performance of the cross-flow plate heat exchangers

Numerical Analysis of Flow Characteristics and Heat Transfer of High-Temperature Exhaust Gas Through Porous Fins

Thermal and acoustic performance of silencing heat exchanger for engine waste heat recovery

Numerical study on heat transfer and resistance performance of heat exchangers with perforated-baffle structure

Airside Thermal–hydraulic Performance Evaluation of Flue Gas Coolers for Waste Heat Recovery

Numerical study of conjugated heat transfer in metal foam filled double-pipe

Thermal Analysis on Metal-Foam Filled Heat Exchangers. Part II: Tube Heat Exchangers

Theoretical Analysis on Heat Transfer in Porous Metal Foam Heat Exchanger

Experimental and numerical studies on novel airfoil fins heat exchanger in flue gas heat recovery system