Abstract:Advances in Structural Engineering, Ahead of Print. This study investigates four different joints under fluctuating tension cycles in the low-cycle fatigue (LCF) regime. The selected material was S960 ultra-high-strength steel, manufactured via the direct-quenching manufacturing route. Based on typical engineering solutions, the following joints were chosen to be investigated in the experimental tests: metal active gas and laser welded butt joints, fillet-welded load-carrying cruciform joints, and non-load-carrying double-sided transverse attachment joints. To evaluate the improvement gained by the post-weld treatment, both as-welded condition and high-frequency mechanical impact treated joints from all joint types were tested. In addition to the experimental tests, some of the joints were analyzed using finite element (FE) models, with the aim of comparing the accuracy of the different fatigue assessment methods and the effect of the toe radius on the computational fatigue lives. The results obtained from the experimental tests and FE analyses were compared with each other and with IIW recommendations using the nominal stress, structural hot-spot (HS) stress, effective notch stress (ENS) and 4R methods. Based on the results, the structural HS and 4R methods are very suitable for the fatigue strength assessment in the LCF regime. With the nominal stress method, the computational fatigue lives remained uniformly conservative, while with the ENS method, the results varied depending on the calculation method. Using the value r = 1 mm as the weld toe rounding is justified in the FE analysis.

On Specimen Design for High Cycle Fatigue Testing of Welded Joint

Low Cycle Fatigue Properties and Fracture Mechanism of Q345qC Steel and Its Welded Joint

Fatigue Testing in Welded Joint of 980- grade Steels

Use of instrumented indentation testing to study local mechanical properties of 304L SS welded joints subjected to low-cycle fatigue loadings

Experimental and Numerical Characterization of Low Cycle Fatigue and Creep Fatigue Behaviour of P92 Steel Welded Joint

An Insight into the Creep-Fatigue Damage Localization in Welded Joints Based on Crystal Plasticity Finite Element Method

Biaxial Very High Cycle Fatigue Testing and Failure Mechanism of Welded Joints in Structural Steel Q345

Notch energy-based low and high cycle fatigue assessment of load-carrying cruciform welded joints considering the strength mismatch

Characterization of the Cyclic Softening and Remaining Creep Behaviour of P92 Steel Weldment

Low cycle fatigue analysis of welded joints considering material cycling behavior

EXPERIMENTAL RESEARCH ON FATIGUE PERFORMANCE AND FRACTURE MECHANISM OF Q345QD BUTT WELDS

Low-cycle fatigue in ultra-high-strength steel welded joints in the as-welded and post-weld-treated conditions

Experimental study of fatigue behaviour of Q690qENH bridge weathering high-strength steel welded joints

Influence of Element Segregation at Grain Boundary of Heat Affected Zone on Low-cycle Fatigue Property of Weldment

Selection Methodology of High-Cycle Fatigue Analysis Approach for Damage Estimation in Welded Structural Joints

Study on Fatigue Behavior and Crack Propagation Life of Longitudinal Fillet Welded Lap Joint

Investigation of the High-Temperature Low-Cycle Fatigue Failure Characteristics of P91 Steel Weld Joints and their Fatigue Strength Reduction Factors under Various Load Control Regimes

Experimental investigations on combined high and low cycle fatigue: Material-level specimen design and strain response characteristics

Heat Dissipation Behavior of a Low-Strength-Steel Welded Joint in Ultrasonic Fatigue

Microstructure and pore sensitivities in very high cycle fatigue behaviors of titanium alloy welded joints under stress ratios

Synthetical Effect of Material Inhomogeneity and Welding Defects on Fatigue Behavior of 2205 Duplex Stainless Steel Cruciform Welded Joints: Experiments and Life-prediction Model