Mechanical behaviour of longitudinal lap-welded joints of high strength steel: Experimental and numerical analysis
Ming-Ming Ran,Fei-Fei Sun,Guo-Qiang Li,Yan-Bo Wang
DOI: https://doi.org/10.1016/j.tws.2020.107286
2021-02-01
Abstract:<p>Mechanical behaviour of twenty-eight longitudinal lap-welded joints made of high strength steels (HSS) under tension load was investigated by experimental and numerical study. Weaknesses due to traditional deformation measurements for fillet welded joints can be perfectly solved by digital image correlation techniques (DIC). Distribution and development of strain field throughout the specimens along the whole loading process were recorded by DIC measurement. The effect of parameters (e.g. weld size, weld length and mismatch ratio) on mechanical properties (e.g. ultimate strength, failure modes, weld ductility and fracture angle) of longitudinal fillet welds and transverse fillet welds, which was introduced in detail in previous work by the authors, were compared. Generally, because of the difference on the combination of shear force and tension force, the fracture angle of longitudinal welded specimens (around <span class="math"><math>50∘</math></span>) were much more divergent from transverse welded specimens (around <span class="math"><math>20∘</math></span>) even though both of them failed at welded zone (welded zone only refers to weld metal in this paper), resulting that the mean strength of longitudinal welded specimens were only 0.58 time of transverse welded specimens. Conversely, the mean deformation capacity of longitudinal welded specimens was almost 4.0 times of transverse welded specimens. All longitudinal welded specimens have "platform" or "decline" feature while all transverse welded specimens have "rise" or "platform" feature load-deformation curves. Generally, the specimens with "rise" feature load-deformation curve are more likely to suffer sudden fracture, while specimens with "decline" or "platform" feature have satisfactory ductility performance. Based on the strain distribution and development features provided by DIC measurement, a new strength criterion, in which the ultimate strain obtained in relevant coupon tests was an indicator, was proposed and through the comparison between the numerical results and test results, its validation was verified by FE simulation. Moreover, it was confirmed that the predicted loads of EC3 and AISC Specification were close and slightly conservative for all specimens.</p>
engineering, mechanical,mechanics, civil