Abstract:Direct contact condensation (DCC) is a phenomenon observed when steam interacts with subcooled water, exhibiting higher heat and mass transfer rates compared to wall condensation. It has garnered significant interest across industries such as nuclear, chemical, and power due to its advantageous characteristics. In the context of pressure-relief tanks, understanding and optimizing the DCC process are critical for safety and efficiency. The efficiency of pressure-relief tanks depends on the amount of steam condensed per unit of time, which directly affects their operational parameters and design. This study focuses on investigating the direct gas–liquid contact condensation process in pressure-relief tanks using computational fluid dynamics (CFD). Through experimental validation and a sensitivity analysis, the study provides insights into the influence of inlet steam parameters and basin temperature on the steam plume characteristics. Furthermore, steady-state and transient calculation models are developed to simulate the behaviour of the pressure-relief tank, providing valuable data for safety analysis and design optimization. There is a relatively high-pressure area in the upper part of the bubble hole of the pressure-relief tube, and the value increases as it is closer to the holes. The steam velocity in the bubbling hole near the 90° elbow position is higher. This study contributes to the understanding of steam condensation dynamics in pressure-relief tanks. When the steam emission and pressure are fixed, the equilibrium temperature increases linearly as the initial temperature increases (where a = 1, b = 20 in y = a x+ b correlation), the equilibrium pressure increases nearly exponentially, and the equilibrium gas volume decreases. When the steam emission and initial temperature are fixed, the equilibrium temperature does not change as the steam discharge pressure increases. The correlations between the predicted equilibrium parameters and the inlet steam parameters and tank temperature provide valuable insights for optimizing a pressure-relief tank design and improving the operational safety in diverse industrial contexts.

Characteristics of Entrapped Bubbles of Periodic Condensation-Induced Water Hammer in a Horizontal Pipe

Experimental investigation of the effect of geometrical and operating variables on condensation induced water hammer in horizontally oriented pipes

Improved CFD simulation of water hammer caused by condensation with an enhanced phase change model

Patterns of direct contact condensation bubbles based on dynamic behaviors and oscillations

The Influence Of Water Characteristics On Plasma-Containing Bubble Dynamics

Enhanced steam condensation heat transfer on a honeycomb-like microporous superhydrophobic surface under different condensing pressures

Experimental investigation on interface characteristics and heat transfer during bubble condensation in narrow rectangular channel

A numerical study on oscillatory characteristics of unstable steam jet in water flow within a vertical pipe

Condensation-induced Steam Bubble Collapse in a Pipeline

Condensation-induced water hammer in a horizontal pipe

Theoretical Study of Steam Condensation Induced Water Hammer Phenomena in Horizontal Pipeline

Numerical Simulation of Condensation-Induced Water-Hammer

Interfacial Characteristics of Steam Jet Condensation in Crossflow of Water in a Vertical Pipe

Three-dimensional computational fluid dynamics simulation of valve-induced water hammer

Dynamic Interaction Between Valve-Closure Water Hammer Wave and Centrifugal Pump

Study of Condensation during Direct Contact between Steam and Water in Pressure-Relief Tank

Experimental Study on Pressure Oscillations of Direct-Contact Condensation between Saturated Steam and Droplets at Sub-Atmospheric Pressure

Experimental study on heat transfer characteristics of steam underwater direct-contact condensation

Experimental Transient Cavitation Bubbles in a Conical-Frustum Shaped Tube

Large cavitation bubbles in the tube with a conical-frustum shaped closed end during a transient process

Experimental investigation on two-phase flow instability induced by direct contact condensation in open natural circulation