Abstract:The formability and mechanical properties of magnesium (Mg) alloys are strongly related to the crystallographic basal texture. Twins play critical roles in adjusting crystallographic orientation of grains during both deformation and annealing treatment via deformation twinning and twinning-assisted recrystallization. In this study, cold rolling and subsequent annealing were conducted on a Mg-5.9Gd-3.3Y-0.5Zr alloy to investigate the recrystallization behavior and texture evolution. Electron backscatter diffraction and transmission electron microscopy techniques were applied to characterize the nucleation of recrystallized grains, especially the twinning-assisted recrystallization, at multi-scales. The results indicated that a large number of {101‾2}, {101‾1} twins and {101‾1}‐{101‾2} double twins were introduced after cold rolling. The {101‾1}‐{101‾2} double twins, double twin - grain boundary intersections and dense twin-twin intersections acted as the preferential nucleation sites for recrystallization during annealing treatment, while the coarse and parallel {101‾2} twins were unfavorable for the nucleation of recrystallized grains. Although {101‾2} tension twins are the most common twins in Mg alloys, the interface of this type of twin has strong mobility and is easy to expand. Therefore, it is generally difficult for a single {101‾2} twin to recrystallize. However, the {101‾1} compression twins and {101‾1}‐{101‾2} double twins are generally difficult to expand and can store high deformation energy, so they are conducive to becoming nucleation sites for recrystallization. During the recrystallization process, the texture type (basal texture) of the cold rolled sample remained unchanged, but the overall texture intensity was significantly reduced due to the dispersion of grain orientations brought by new grains generated by twinning recrystallization.

Influence of Twinning-Induced Recrystallization on Texture Evolution in a High Strain Rate Compressed Mg-Zn Alloy

Twin recrystallization mechanisms in a high strain rate compressed Mg-Zn alloy

Twinning-Assisted Static Recrystallization and Texture Evolution in A Mg-Gd-Y-Zr Alloy

Unusual Twin Induced Recrystallization and Corresponding Texture Optimization in a Cold Rolled Mg-Gd-Zr Alloy During Annealing

Strain Rate and Texture Effects on Microstructural Characteristics of Mg-3al-1zn Alloy During Compression

Influence of precipitation on tension and compression twinning in Mg-6.5Zn alloy

Twinning Effects on the Hot Deformation Behavior of AZ31 Mg Alloy

Quantitative investigation on the {10–12} twinning-detwinning behavior and twinning transfer of an extruded Mg-2.8Y sheet during compression-tension loading via quasi-in-situ EBSD observation

Texture weakening effect from { 10 1 ̅ 1 } twins induced static recrystallization in ambient extrusion AZ31 magnesium alloy

Twinning and Mechanical Behavior of an Extruded Mg–6Al–3Sn Alloy with a Dual Basal Texture

Texture tailoring and microstructure refinement induced by {11−21} and {10−12} twinning in an extruded Mg-Gd alloy

Effect of Deformation Mode on Double-Peak Texture Evolution in Pre-Twinning Mg-3Al-1Zn Alloy During High-Speed Impacting Loading

{ 10 1 ̄ 2 } twin–twin intersection-induced lattice rotation and dynamic recrystallization in Mg–6Al–3Sn–2Zn alloy

Twin recrystallization mechanisms in magnesium-rare earth alloys

Twinning Behavior, Microstructure Evolution and Mechanical Property of Random-Orientated ZK60 Mg Alloy Compressed at Room Temperature

Effect of twinning on the deformation behavior of an extruded Mg-Zn-Zr alloy during hot compression testing

Ex-situ EBSD Analysis of Yield Asymmetry, Texture and Twinning Development in Mg–5Li–3Al–2Zn Alloy During Tensile and Compressive Deformation

Quasi-in-situ Observations of Low-Angle Grain Boundaries, Twins and Texture Evolution During Continuous Annealing in a Cold-Rolled Mg-Zn-Gd Alloy

EBSD Analysis and Theoretical Prediction of Twin Orientations During Compression in Mg-3Al-1Zn

Direct observation of annealing-driven recrystallization behavior in magnesium alloy at low strain condition

The Effect of Twin–twin Interaction in Mg 3al 1zn Alloy During Compression