Abstract:Pulsating heat pipes (PHPs) are widely used in the heat dissipation of electronic components, waste heat recovery, solar energy utilization, etc., relying on the pulsating flow of the work material in the pipe and the heat transfer by phase change, and they have the advantages of high heat-transfer efficiency, simple structure, and low cost. In this paper, an experimental method is used to adjust the length of local pipes in the PHP structure, so that the PHP forms a high- and low-staggered asymmetric structure, and to study the effects of different liquid charging rates and heat-source temperatures on the vibration, startup, and operation of the PHP in the asymmetric structure. We found the following: it is difficult to start up and operate the workpiece at 10%, 68%, and 80% liquid charging rates; the effect of the oscillating impact is worse; the temperature difference between the evaporation section of the pulsating heat pipe and condensation section is larger; and the temperature difference between the evaporation section and condensation section is larger. The temperature difference between the evaporation section and condensation section of the pulsating heat pipe is large, the temperature difference is between 10~25 °C, and it is difficult to achieve a small temperature difference in heat transfer. When the liquid charging rate is 30% and 50%, the pulsating heat pipe oscillates better; the pulsation frequency is relatively high; and the temperature difference between the end of the cold and hot sections is small, the temperature difference is between 3 and 7 °C, and the performance of heat transfer is better. However, when the liquid charging rate is 30% and the heat source is 70 °C, the thermal resistance is increased to 0.016 K/W, and the equivalent thermal conductivity is reduced. When the performance of heat transfer is changed to 0.016 K/W and the equivalent thermal conductivity is reduced, the coefficient decreases, and the heat-transfer performance becomes weaker.

Experimental investigation of effects of extremely low pumping speed on isothermal performance and filling ratio of sintered copper heat pipe

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Experimental investigation on a pulsating heat pipe with low number of turns at liquid hydrogen temperature range

Experimental Study on the Thermo-Hydrodynamic Characteristics of a Nitrogen Pulsating Heat Pipe

Filling Ratio Optimization for High-Performance Nanoengineered Copper-Water Heat Pipes

Effects of filling ratio, geometry parameters and coolant temperature on the heat transfer performance of a wraparound heat pipe

Mesoscopic numerical study of the startup characteristics of grooved heat pipe under high heat flux

Effect of deionized water on heat transfer characteristics of gravity heat pipe

Experimental Study of Thermal Performance of Pulsating-Heat-Pipe Heat Exchanger with Asymmetric Structure at Different Filling Rates

Experimental Investigation of Thermal Conduction Performance on Silicon-Based Micro Flat Heat Pipe

Numerical investigation into the gas-liquid two-phase flow regime and heat transfer characteristics in a gravity heat pipe

Experimental investigation and multiparameter analysis of variable conductance heat pipes

Effect of inventory on the heat performance of copper-water loop heat pipe

Heat Transfer Performance and Startup Characteristics of Separated Gravity Heat Pipe

Experimental Research on the Heat Performance of a Flat Copper-Water Loop Heat Pipe with Different Inventories

Effect of evaporation and condensation section length ratio on thermal performance of aluminum flat plate heat pipe with different micro grooved wicks

A discussion of internal flow characteristics and performance of super long gravity heat pipes for deep geothermal energy extraction

Experimental Study on Sodium Screen-Wick Heat Pipe Capillary Limit

Numerical Evaluation of Non-Condensable Gas Influence on the Heat Transfer Characteristics of High-Temperature Lithium Heat Pipe During Reactor Operation

High Performance Copper-Water Heat Pipes with Nanoengineered Evaporator Sections

Experimental study on frozen startup and heat transfer characteristics of a cesium heat pipe under horizontal state