Abstract:<p>Gm-APD (Geiger-mode avalanche photodiode) is widely used in the LiDAR (Light detection and ranging) system for its excellent photon detection capability. The triggering probability of Gm-APD is closely dependent on the absolute intensity and the signal-to-noise ratio (SNR) of the echo, which limits the detection results in the daytime. In order to improve target's detection probability under a limited amount of statistics in the daytime, it proposed a detection scheme by using the spatial correlation and adaptive adjustment of the aperture diameter (AAAD) to achieve optimal target detection results in the daytime, besides, a MLE (Maximum Likelyhood Estimation) based ranging walk-error correction method was also put forward for the limited number of measurement. Firstly, considering the strategies of AAAD and spatial correlation, as well as the LiDAR ranging equation and Poisson triggering probability model, the detection probability model and ranging performance model of the scheme of spatial correlation and AAAD were built in this paper. Subsequently, the detection probability and ranging performance of the proposed scheme were theoretically analyzed, besides, a ranging walk-error correction strategy was put forward based on the MLE method. The theoretical analysis results showed that the proposed detection scheme could increase the utilization of echo photons and improve the amount of echo's triggering statistics; moreover, the Monte Carlo simulation results showed that in the case of a limited amount of statistics, the target detection scheme and ranging walk-error correction strategy could effectively improve the target detection probability and obtain a smaller ranging walk-error than the traditional detection scheme. Finally, the Gm-APD LiDAR was used to experimentally verify the proposed scheme, and the results showed that the scheme could effectively improve the echo's triggering probability with 400 measurements; the indoor experiment showed that the triggering probability could be improved by 7.54 times at most for white wall, and the white wall's target restoration ratio could reach 100% which was enhanced by more than 100%; besides, the outdoor experiment in the daytime showed that the target's restoration ratio could reach 75.54% and 99.45% for two investigated regions which were enhanced by 659.2% and 57.4%. Moreover, a high ranging accuracy could be maintained through ranging walk-error correction strategy, ranging walk-errors of -9mm, 12mm and 14mm under 400 measurements were achieved for white wall, concrete slab and black paper respectively. It effectively improved the ranging performance compared with the traditional detection scheme, and it completely satisfied the far-range detection. This paper can provide effective solutions for laser detection and ranging with Gm-APD in the daytime.</p>

Improved Imaging Quality of Cluster LiDAR by Optimizing Laser Energy Distribution Using an Effective Optical Approach

Optimization of System Design and Calibration Algorithm for SPAD-Based LiDAR Imager

Correction of Linear-Array Lidar Intensity Data Using an Optimal Beam Shaping Approach

Adjustable Higher SNR and Long-Range 3D-Imaging Cluster Lidar Based on a Coded Full-Waveform Technique

A Hybrid Solid-State Beam Scanner for LiDAR Applications

Design of an Array Collimating System Based on VCSEL Light Source

Enhancing signal-to-noise ratio in active laser imaging under cloud and fog conditions through combined matched filtering and neural network

Toward Intelligent Sensing: Optimizing Lidar Beam Distribution for Autonomous Driving

A simulation imaging method for actual optical system and results analysis

Enhancing Angular Resolution in Single-Photon LIDAR for Daytime Long-Range 3D Imaging

Design of Lidar Receiving Optical System with Large FoV and High Concentration of Light to Resist Background Light Interference

Nonuniformity of diffractive splitting and receiver-transmitter alignment for large-field-of-view hundred-beam-scale LiDAR

Improvement of detection probability and ranging performance of Gm-APD LiDAR with spatial correlation and adaptive adjustment of the aperture diameter

Spatially modulated scene illumination for intensity-compensated 2D array photon-counting LiDAR imaging

Detection performance improvement method of single-photon LiDAR by the combination of speckle suppression with adaptive adjustment of aperture diameter and spatial correlation method

Spatial and Temporal Multiplexing Array Imaging Lidar Technique Based on OOCDMA

Laser-echo reduction method based on a multifocal lens array

New Scheme of MEMS-Based LiDAR by Synchronized Dual-Laser Beams for Detection Range Enhancement

Airborne Single-Photon LiDAR Towards a Small-Sized and Low-Power Payload

Optical–Mechanical Integration Analysis and Validation of LiDAR Integrated Systems with a Small Field of View and High Repetition Frequency

Study on Laser Parameter Measurement System Based on Cone-Arranged Fibers and CCD Camera