Influences of Non-Ionic Branches on the Properties of the Anion Exchange Membranes Based on Imidazolium Functionalized Poly (2, 6-Dimethyl-1, 4-Phenylene Oxide)

Ruiying Wan,Dengji Zhang,Shaoshuai Chen,Niya Ye,Yunfei Yang,Ronghuan He

DOI: https://doi.org/10.1016/j.eurpolymj.2019.109463

IF: 6

2019-01-01

European Polymer Journal

Abstract:Different nonionic groups were, respectively, grafted onto the backbone of 1,2,4,5-tetramethylimidazolium functionalized poly(2,6-dimethyl-1,4-phenyleneoxide) to fabricate anion exchange membranes (AEMs). The presence of the nonionic branches significantly decreased the water swelling of the AEMs by 145% compared to that of the original imidazolium functionalized PPO (Im-PPO) with a comparable hydration level (lambda) of around 20. The membrane possessing side chains of the 2-ethoxyethanamine exhibited a hydroxide conductivity of 64 mS cm(-1) at 80 degrees C, while that lm-PPO only showed a conductivity of 48 mS cm(-1) under the same conditions. It is found that the presence of ether-containing side chains facilitated formation of more obvious hydrophilichydrophobic nanoscopic domains according to the images of atomic force microscope (AFM), and the results of small angle X-ray scattering (SAXS) of the membranes. As a result, the AEM grafted with 2-ethoxyethanamine or 3-methoxypropylamine exhibited higher tensile stress at break and lower methanol permeability than that the pristine Im-PPO membrane. In addition, the ether-containing branches allowed the AEMs to exhibit high alkaline stability. A conductivity of about 54 and 47 mS cm(-1) was retained after immersed this kind of AEMs in 1 M KOH at 60 degrees C for 300 and 750 h, respectively.