Abstract:In the process of strip rolling, mill vibration induces vertical and horizontal displacements in the rolls and rolled parts, affecting the accuracy of the rolling analysis model. Constant changes occurred in the rolling zone between the upper and lower working rolls due to mill vibration, resulting in slight vertical and horizontal displacements of the rolled pieces. These displacements, subsequently, affected the precision and accuracy of the rolling analysis model. A dynamic rolling force optimization model was established in this paper based on the Karman differential equation, metal flow equation, and mixed lubrication friction model. This model took into account the small displacements in both vertical and horizontal directions of the rolled parts, effectively addressing the issue of rolling area variation. A vertical–horizontal coupling vibration model for the cold rolling mill was developed, employing the dynamic rolling force model and lumped mass method. The accuracy of the dynamic rolling force model was validated, and a comprehensive examination of the vibration mechanism of the rolling mill, including exploration of suppression methods, was conducted. The amplitude-frequency response of the coupled vibration system was determined using the multiple scales method, and the effects of external excitation and mill structure parameters on the coupled vibration characteristics were analyzed. The results indicated that the dynamic rolling force optimization model had considered the variations in rolling parameters and could explore the complex vibration patterns of the rolling mill itself from the perspective of varying rolling parameters, effectively addressing the issue of rolling region changes. Furthermore, it exhibited high precision in analyzing vertical and horizontal coupling vibrations in the rolling mill. The simulation results indicated that the primary cause of distance vibrations between the rollers was internal resonance triggered by similar external excitation frequencies and derived frequencies coupled in both vertical and horizontal directions. This was subsequently followed by the movement displacement of the hydraulic cylinder piston and changes in coupling parameters, which had a significant impact on the amplitude and resonance region of the vibration system.

Multi-roll Levelling Method for Longitudinal Waves in Metal Sheet Based on a Coupled Curvature Integration Model

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

Multi-roll Levelling for Wave Defects of Metal Sheets Based on the Beam-Membrane Method

A Novel Modeling Method in Metal Strip Leveling Based on a Roll-Strip Unit

An Efficient Multi-Scale Modeling Method that Reveals Coupled Effects Between Surface Roughness and Roll-Stack Deformation in Cold Sheet Rolling

An analytical model for designing defect-free sheet metal profiles with height-variable cross sections manufactured by Flexible Roller Beading

Mathematical modeling of the internal bending moment at the top roll contact in multi-pass four-roll thin-plate bending

Theoretical Study of Asymmetric Bending Force on Metal Deformation in Cold Rolling

Research on quarter-wave control in DP980 steel during cold rolling based on multi-pass simulation

Generation mechanism of high-order waves in wide titanium strip under the control of the first intermediate taper roll of a 20-high mill

Coupled Vertical–Horizontal Vibration Characteristics of a Cold Rolling Mill Based on an Optimized Karman Differential Equation

Calculation method and analysis of residual stress in the strip bending roller straightening process

Study on quarter-wave control of DP980 steel based on a bending force linear combination strategy

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

Deformation mechanism analysis of three-roller continuous and synchronous calibration process of straightness and roundness for LSAW pipes

A Two-Wavelength Model of Surface Flattening in Cold Metal Rolling with Mixed Lubrication

Influence of bending angle function on local thinning defects of roll-formed sheets based on segmental boundary combination optimization

A coupling model of vertical rolling process based on upper bound method and elastic theory

Experimental and Theoretical Study on Forming Film Properties of Hollow Cylindrical Rollers

Through-Thickness Modelling of Metal Rolling using Multiple-Scale Asymptotics

An improved Marciniak-Kuczynski approach for predicting sheet metal formability