Abstract:In the study numerical simulations are performed to investigate the saturated fluid flow through a two dimensional microchannel (1000μm×200μm, with a superheated bottom wall) by building a comprehensive physical method and updating the standard solver in the OpenFOAM software package. On basis of previous numerical study, most of the numerical methods for the micro-scale flow boiling emphasizes the mass transfer and interfacial heat exchange. Simultaneously, geometric reconstruction technology for liquid-vapor interface is widely used, which evidently captures the interfacial boundary characteristic accurately but costs lots of computational resources. In the present study, the temperature recovery model is adopted to maintain the liquid-vapor interface temperature, and an interface-cell searching algorithm is added into the model, while the geometric interface reconstruction technology is abandoned. For the validation of the new codes developed in OpenFOAM, 1-d Stefan Problem and the experimental results of Mukherjee are both utilized to compare with our simulation results. The growth process of a single bubble in the laminar flow regime is studied in order to explore the underlying mechanism of flow boiling in microchannels. The qualitative investigation for effects of wall superheat, Reynolds number, contact angle and surface tension on heat transfer are comprehensively discussed. In general, heat flux of the bottom wall increases because of the motion of liquid-vapor interface. Wall superheat determines the rate of bubble growth on the heated wall, which is roughly proportional to wall heat flux due to the Fourier’s Law. The distribution of velocity and temperature fields in the channel refresh progressively with increasing inflow Reynolds number, which speeds up the evolution of interface position and augments the wall heat flux significantly. Furthermore, the area of thin liquid film between the wall and the bubble is enlarged by reducing the contact angle, thus augmenting the wall heat flux by several times compared with the single phase microchannel flow. However, surface tension and gravitational acceleration are found to be negligible in the present study.

Three-dimensional numerical simulation of saturated annular flow boiling in a narrow rectangular microchannel

Bubble Dynamics of Water Boiling Heat Transfer in Vertical Rectangular Mini-Channel

Numerical simulation of boiling behavior in vertical microchannels

3D Numerical Investigation on Flow Boiling Characteristics in Large Length-to-diameter Ratio Microchannel

Three Dimensional Numerical Simulation on Bubble Growth and Merger in Microchannel Boiling Flow

Numerical Simulation of Micro Scale Flowing and Boiling

Experimental and Numerical Studies on Enhanced Flow Boiling in Tube with Superwetting Micro-Finned Surfaces

Experimental Study Of Saturated Flow Boiling In Vertical Narrow Microchannel

3-D numerical study of subcooled flow boiling in a horizontal rectangular mini-channel by VOSET

Local Heat Transfer of Saturated Flow Boiling in Vertical Narrow Microchannel

Three-Dimensional Numerical Simulation for Annular Condensation in Rectangular Microchannels

Heat Transfer Characteristics And Flow Pattern Visualization For Flow Boiling In A Vertical Narrow Microchannel

Heat Transfer Model Based on Flow Pattern During Flow Boiling in Rectangular Microchannels

Numerical Simulation and Experimental Observations of Confined Bubble Growth During Flow Boiling in a Microchannel with Rectangular Cross-Section of High Aspect Ratio

Experimental Study on Local Subcooled Flow Boiling Heat Transfer in A Vertical Mini-Gap Channel

A four-zone model for saturated flow boiling in a microchannel of rectangular cross-section

The Experimental Research on Subcooled Flow Boiling in Vertical Narrow Rectangular Channels with Relatively Wide-Ranged Parameters

Simulation on Nucleate Boiling in Micro-Channel

K-2206 Experimental Study on Heat Transfer of Boiling Two-Phase Flow in Narrow Annular Channel

SIMULATION OF SINGLE BUBBLE GROWTH IN A PLANAR MICROCHANNEL WITH TEMPERATURE RECOVERY MODEL