Abstract:The vector control of the permanent magnet synchronous motor (PMSM) is affected by cross-coupling, output delay, parameter mismatch, and other factors; thus, resulting in its poor steady-state and insufficient dynamic performance. To address these problems, the design proposed in this study adopts a model predictive current control strategy. In the traditional model predictive control, the absolute value of the difference between the predicted output current of the inverter and the reference current is used as the cost function instead of the minimum value of the valence function, i.e., the optimal solution of the system, and the best switching state is outputted. The design proposed in this study adopts the dual-vector model to predict the current control. Firstly, the reference voltage vector was predicted on basis of the deadbeat idea, which reduced the calculation burden of processor. Next, in order to further improve the stability of the system, a two-vectors duty cycle calculation method was introduced. Then, simplifies the selection range of the two voltage vectors. While ensuring the accuracy of the voltage vector, the control is reduced. Reduce the amount of calculation in the system, thereby improving its robustness. Finally, based on the principle of current vector tracking error minimization, the duration of the selected voltage vector was determined. Last but not the least, the control strategy is applied to the MTPA control to increase the operating efficiency of the control motor. The improved control strategy can effectively reduce the torque ripple and improve the dynamic and steady-state performance of the system. Simulation results verify the feasibility and effectiveness of the proposed control algorithm.

MTPA Control Strategy for Six-phase DC-biased Hybrid Excitation Vernier Reluctance Machines

Dual Closed-Loop Control Strategy on Harmonic Plane for Multiphase Induction Motor with Harmonic Injection Based on Air-Gap Flux Orientation Control

A Sequential Direct Torque Control Scheme for Seven-Phase Induction Machines Based on Virtual Voltage Vectors

Power Perturbation Based Virtual Signal Injection Control of MTPA for IPMSM Drive System

A Calibration Strategy for EV Drives Based on Improved MTPV Table Decoupled from Permanent Magnet Flux Linkage Variation

Maximum Torque Per Ampere Control of IPMSM Based on Online Parameter Identification Considering Cross-coupling and Saturation Effects

An Effective Direct Torque Control Based on Space Vector Modulation for DTP-PMSM

Modeling and Current Control Strategy for Novel Two-Phase DC-Biased Vernier Reluctance Machine

MTPA Control for Scalar Controlled Synchronous Reluctance Motor

New Optimal Current Control Strategy for Six-Phase DC-Biased Vernier Reluctance Machines Considering Distorted EMF

MTPA Control and Flux-Weakening Control for IPMSM Drives Based on High-frequency Signal Injection

An Improved Model Predictive Direct Torque Control Strategy for Reducing Harmonic Currents and Torque Ripples of Five-Phase Permanent Magnet Synchronous Motors.

A Novel MTPA Control Strategy for Multiple Torque Component Single Air Gap Magnetless Machines

A MTPA Control Strategy for Mono-Inverter Multi-PMSM System

An Error Tracking Dead-beat Model Predictive Torque Control for Open-Winding Permanent Magnet Synchronous Motor with Common DC Bus

Comparative Research of MTPA Control for Interior PMSM Used in Electric Vehicles

A Robust MTPA Controller for High Efficiency IPM Synchronous Motor

Direct Torque Control Combined with Mtpa Concept for Open Winding Ipmsm

Maximum Torque Per Ampere (MTPA) Control Based on Online Calculation of Inductance Increment

MTPA control of permanent magnet synchronous motor based on dual-vector model predictive control

Maximum Torque Per Ampere (MTPA) Control for IPMSM Drives Based on a Variable-Equivalent-Parameter MTPA Control Law